Wyo. Code R. 012-0001-9
Architects and Landscape Architects, Board of
Chapter 9: Seal Specifications and Use
Effective Date: 12/19/2011 to 01/08/2015
Rule Type: Superceded Rules & Regulations
Reference Number: 012.0001.9.12192011
(a) Each licensed architect and landscape architect's seal shall be no less than 1½' and no more than 2' in diameter. It shall contain the name of the licensed architect or landscape architect; his/her license number, the word 'Date:', and the words 'LICENSED ARCHITECT-STATE OF WYOMING' or 'LICENSED LANDSCAPE ARCHITECT-STATE OF WYOMING' as appropriate. This seal shall approximate the format shown below:
(i) The seal design adopted by the Board in the Rules and Regulations dated April 27, 2001, as it appears below, will be accepted for persons licensed prior to the effective date of these rules.
(ii) The seal design adopted by the Board in the Rules and Regulations dated June 18, 1992, as it appears below, will be accepted for persons licensed prior to April 27, 2001.
(b) The format of the seal may be a rubber stamp, an embosser, or a digital image.
(c) Each licensee is responsible for procuring their own seal.
(a) The seal shall be imprinted on all technical submissions, as follows:
(i) On each final design and each final drawing;
(ii) On the cover, title or index pages of each set of specifications; and
(iii) On the cover or index page of all other technical submissions.
(b) The original signature of the individual named on the seal shall appear across the face of each original seal imprint, along with the date of signing. Digital seals and signatures are acceptable; however, it is the responsibility of the licensee to provide adequate security when documents with digital seals are distributed.
(c) The seal appearing on any technical submission shall be prima facie evidence that said technical submission was prepared by or under the responsible control of the individual named on said seal only if the seal has been signed and dated.