1. (a) If a system does not comply with applicable standards adopted at the time the system was installed, a completed yellow label must be attached to the outside of the control panel cover or, if the system has no panel, in a permanently visible location to indicate that corrective action is necessary.
2. (b) The signature of the licensee on a yellow label certifies that the conditions listed on the label cause the system to be out of compliance with applicable standards.
3. (c) Yellow labels must be at least three inches in height and three inches in width and be of a gummed label type that allows for label removal. Labels must be printed with black lettering.

4. (d) Yellow labels must bear the following information in the format of the label shown in subsection (f) of this section:

   1. (1) the inscription "DO NOT REMOVE BY ORDER OF THE STATE FIRE MARSHAL--SYSTEM DOES NOT COMPLY WITH APPLICABLE STANDARDS" (all in capital letters, at least 10-point boldface type);
   2. (2) the firm's name, address, and telephone number (either main office or branch office);
   3. (3) the firm's certificate-of-registration number;
   4. (4) the signature and license number of the certifying licensee (a stamped signature is prohibited);
   5. (5) the date the label is affixed; and
   6. (6) a list of the noncomplying conditions.
5. (e) A yellow label may be removed only by a licensed employee of a registered firm that has corrected the conditions and certified the service.
6. (f) Yellow label:
7. (g) A contractor shall comply with the provisions specified in §34.620(g) of this title (relating to Installation and Service Labels).

Source Note:The provisions of this §34.621 adopted to be effective February 27, 1995, 20 TexReg 1021; amended to be effective November 27, 1995, 20 TexReg 9449; transferred effective September 1, 1997, as published in the Texas Register November 14, 1997, 22 TexReg 11091.