PURPOSE: This regulation restricts the emission of particulate matter in the source gas of an operation or activity except where 10 CSR 10-2.040, 10 CSR 10-2.090, 10 CSR 10-6.070 or combination of these apply.

1. (1) General Provisions.

   1. (A) This regulation applies to any operation, process or activity except the burning of fuel for indirect heating in which the products of combustion do not come into direct contact with process materials, the burning of refuse and the processing of salvageable material by burning and catalytic cracking units at petroleum refineries.

   2. (B) Process weight means the total weight of all materials introduced into a source operation, including solid fuels, but excluding liquids and gases used solely as fuels and excluding air introduced for purposes of combustion. Process weight rate means a rate established as follows:

      1. 1. For continuous or long run steady

state source operations, the total process weight for the entire period of continuous operation or for a typical portion, divided by the number of hours of each period or portion;

1. 2. For cyclical or batch source opera-

tions, the total process weight for a period which covers a complete operation or an integral number of cycles, divided by the hours of actual process operation during this period; and

1. 3. Where the nature of any process or

operation or the design of any equipment is such as to permit more than one (1) interpretation of this subsection, that interpretation which results in the minimum value for allowable emission shall apply.

1. (C) The amount of particulate matter emitted shall be determined as specified in 10 CSR 10-6.030(5). Any other method which is in accordance with good professional practice may be used with the consent of the staff director.

1. (2) Emission Limitations.

   1. (A) Except as provided for in subsection (2)(B) and section (3) of this regulation, no person shall cause, suffer, allow or permit the emission of particulate matter in any one (1) hour from any source in excess of the amount shown in Table I following for the process weight allocated to that source:

      Table I

Process Weight Rate Lb/Hr Tons/Hr

1,000 1,500 2,000 2,500 3,000 3,500 4,000 5,000 6,000 7,000 8,000 9,000 10,000 12,000 16,000 18,000 20,000 30,000 40,000 50,000 60,000 70,000 80,000 90,000

100,000 120,000 140,000 160,000 200,000 1,000,000 2,000,000 1,000.00 6,000,000 3,000.00 Emission

0.05 0.10 0.20 0.30 0.40 0.50 0.75 1.00 1.25 1.50 1.75 2.00 2.50 3.00 3.50 4.00 4.50 5.00 12.0 6.00 13.6 8.00 16.5 9.00 17.9 10.00 19.2 15.00 25.2 20.00 30.5 25.00 35.4 30.00 40.0 35.00 40.00 42.5 45.00 43.6 50.00 44.6 60.00 46.3 70.00 47.8 80.00 49.0 100.00 500.00 69.0 77.6 92.7 10 CSR 10-2

Interpolation of the data in this table for process weight rates up to 60,000 lb/hr shall be accomplished by use of the equation E= 4.10P0.67 and interpolation and extrapolation of the data for process weight rates in excess of 60,000 lb/hr shall be accomplished by use of the equation: E = 4.10P0.67 and interpolation and extrapolation of the data for process weight rates in excess of 60,000 lb/hr shall be accomplished by use of the equation— E=55.0(P)0.11 – 40 where E = rate of emission in lb/hr; and P = process weight in tons/hr.

1. (B) The limitations established by subsection (2)(A) of this regulation shall not require the reduction of particulate matter concentra-

Rate of tion, based on the source gas volume, below the concentration specified in Table II follow- Lb/Hr ing for that volume; provided that, for the 0.551 purpose of this subsection (2)(B), the person 0.877 responsible for the emission may elect to sub- 1.40 stitute a volume determined according to the 1.83 provisions of subsection (2)(C) of this regula- 2.22 tion; and provided further that the burden of 2.58 showing the source gas volume or other vol- 3.38 ume substituted, including all the factors 4.10 which determine the volume and the methods 4.76 of determining and computing the volume, 5.38 shall be on the person seeking to come within the provisions of this subsection: 5.96 6.52 Table II 7.58 8.56 Source Gas Concentration 9.49 Volume, Standard Grain Per Cubic Foot 10.4 Per Minute Cubic Foot 11.2 7,000 or less 8,000 9,000 10,000 20,000 30,000 40,000 50,000 60,000 80,000 100,000 41.3 120,000 140,000 160,000 180,000 200,000 300,000 400,000 51.2 500,000 600,000 800,000 1,000,000 or more Standard

0.100 0.096 0.092 0.089 0.071 0.062 0.057 0.053 0.050 0.045 0.042 0.040 0.038 0.036 0.035 0.034 0.030 0.027 0.025 0.024 0.021 0.020

1. (C) Any volume of gases passing through and leaving an air pollution abatement operation may be substituted for the source gas volume of the source operation served by air pollution abatement operation, for the purposes of subsection (2)(B) of this regulation provided the air pollution abatement operation emits no more than forty percent (40%) of the weight of particulate matter entering and provided further that the substituted volume shall be corrected to standard conditions and to a moisture content no greater than that of any gas stream entering the air pollution abatement operation.
2. (D) Notwithstanding the provisions of subsections (2)(A) and (B) of this regulation, no person may cause, allow or permit the emission of particulate matter from any source in a concentration in excess of 0.30 grain per standard cubic foot of exhaust gas.

1. (3) Exceptions.

   1. (A) The provisions of subsections (2)(A)–

2. (D) of this regulation shall not apply to existing grey iron jobbing cupolas. For purposes of this regulation, a jobbing cupola is defined as a cupola which has a single melting cycle operated no more than ten (10) hours in any consecutive twenty-four (24) hours and no more than fifty (50) hours in any consecutive seven (7) days.

   1. 1. All existing grey iron jobbing cupolas

shall be equipped with gas cleaning devices and so operated as to remove not less than eighty-five percent (85%) by weight of all the particulate matter in the cupola discharge gases or release not more than 0.4 grain of particulate matter per standard cubic foot of discharge gas, whichever is more stringent.

1. 2. All gases, vapors and gas entrained

effluents from the cupolas shall be incinerated at a temperature not less than twelve hundred degrees Fahrenheit (1200°F) for a period of not less than 0.3 seconds.

1. (B) The provisions of subsections (2)(A)—

1. (D) of this regulation shall not apply to the drying process in existing corn wet milling operations. All existing corn wet milling drying processes shall be equipped with gas cleaning devices and so operated as to remove not less than ninety-nine and one-half percent (99.5%) by weight of all particulate matter in the dryer discharge gases.

   1. (C) The provisions of this regulation shall not apply to a process during periods when a new fire is being built, during the start-up of the operation, during an operational breakdown or while air pollution control equipment is being cleaned or repaired.

   2. (D) This regulation shall not apply to the emissions from—

      1. 1. The grinding, crushing and classify-

ing operations at a rock quarry; or

1. 2. The receiving and shipping of whole

grain from or into a railroad or truck transportation source at a grain elevator.

AUTHORITY: section 203.050, RSMo (1986). Original rule filed Dec. 26, 1968, effective Jan. 5, 1969. Amended: Filed June 30, 1975, effective July 9, 1975. Amended: Filed March 15, 1979, effective Nov. 11, 1979. Amended: Filed July 16, 1979 effective Feb. 11, 1980. Amended: Filed Oct. 13, 1983, effective March 12, 1984. Op. Atty. Gen. No. 331, Shell, 11-15- 71. The Missouri Air Conservation Commission has the authority under Chapter 203, RSMo (1969) and the Constitution of Missouri to enforce without delay the provisions of Chapter 203, RSMo (1969) and standards and regulations, through administrative procedures and injunctive relief.