(1) The following are minimum safety equipment requirements for a custom vehicle:
- (a) hydraulic service brakes on all wheels with current vehicle brake and stopping standards;
- (b) parking brake operating on at least two wheels on the same axle;
- (c) seat belts for all passengers and driver;
- (d) sealed beam or halogen headlamps;
- (e) brake Lamps;
- (f) turn signal lamps and switch;
- (g) AS-1 safety glass or Lexan; and
- (h) electric or vacuum windshield wiper in front of the drivers view.
- (2) The inspector shall issue a rejection inspection certificate when any of the above requirements are not met.
- (3) Exhaust systems may discharge along the side of the vehicle provided they discharge at a point behind the rear edge of the door and exhaust is directed away from the vehicle.
(4) The vehicle identification for a custom vehicle shall be a number stamped on the frame of the vehicle.
- (a) If no such numbers exist, then the requirements as established pursuant to Rule R873-22M-15 must be followed in order to pass inspection.
- (5) All safety equipment of a replica vehicle shall comply with the requirements in Subsection 41-6a-1507(3).
KEY: motor vehicle safety, safety inspection manual
Date of Last Change: December 6, 2018
Notice of Continuation: April 29, 2026
Authorizing, and Implemented or Interpreted Law: 53-8-204; 53-8-205; 41-6a-1601