(c) Blasters.

1. (1) No later than 12 months after the blaster certification program required by Subchapter 65 of this Chapter has been approved, all surface blasting operations incident to underground mining in the State shall be conducted under the direction of a certified blaster. Before that time, all such blasting operations in that State shall be conducted by competent, experienced persons who understand the hazards involved.
2. (2) Certificates of blaster certification shall be carried by blasters or shall be on file at the permit area during blasting operations.
3. (3) A blaster and at least one other person shall be present at the firing of a blast.

4. (4) Any blaster who is responsible for conducting blasting operations at a blasting site shall:

   1. (A) Be familiar with the site-specific performance standards; and
   2. (B) Give direction and on-the-job training to persons who are not certified and who are assigned to the blasting crew or assist in the use of explosives.

(d) Blast design.

1. (1) An anticipated blast design shall be submitted if blasting operations will be conducted within:

   1. (A) 1,000 feet of any building used as a dwelling, public building, school, church or community or institutional building; or
   2. (B) 500 feet of active or abandoned underground mines.
2. (2) The blast design may be presented as part of a permit application or at a time, before the blast, approved by the Department.
3. (3) The blast design shall contain sketches of the drill patterns, delay periods, and decking and shall indicate the type and amount of explosives to be used, critical dimensions, and the location and general description of structures to be protected, as well as a discussion of design factors to be used, which protect the public and meet the applicable airblast, flyrock, and ground-vibration standards in Section 460:20-45-22.
4. (4) The blast design shall be prepared and signed by a certified blaster.
5. (5) The Department may require changes to the design submitted.