(a) General. Each application shall include geologic information in sufficient detail to assist in-

1. (1) Determining the probable hydrologic consequences of the operation upon the quality and quantity of surface and ground water in the permit and adjacent areas, including the extent to which surface- and ground-water monitoring is necessary;
2. (2) Determining all potentially acid- or toxic-forming strata down to and including the stratum immediately below the coal seam to be mined;
3. (3) Determining whether reclamation as required by these Regulations can be accomplished and whether the proposed operation has been designed to prevent material damage to the hydrologic balance outside the permit area; and
4. (4) Preparing the subsidence control plan under Section 460:20-31-13 of this Chapter.

(b) Geologic information shall include, at a minimum, the following:

1. (1) A description of the geology of the proposed permit and adjacent areas down to and including the deeper of either the stratum immediately below the lowest coal seam to be mined or any aquifer below the lowest coal seam to be mined which may be adversely impacted by mining. This description shall include the areal and structural geology of the permit and adjacent areas, and other parameters which influence the required reclamation and it shall also show how the areal and structural geology may affect the occurrence, availability, movement, quantity, and quality of potentially impacted surface and ground water. It shall be based on:

   1. (A) The cross sections, maps, and plans required by Section 460:20-29-11 of this Chapter;
   2. (B) The information obtained under (b) (2), (b) (3), and (c) of this Section; and
   3. (C) Geologic literature and practices.

2. (2) For any portion of a permit area in which the strata down to the coal seam to be mined will be removed or are already exposed, samples shall be collected and analyzed from test borings; drill cores; or fresh, unweathered, uncontaminated samples from rock out crops down to and including the deeper of either the stratum immediately below the lowest coal seam to be mined or any aquifer below the lowest coal seam to be mined which may be adversely impacted by mining. The analyses shall result in the following:

   1. (A) Logs showing the lithologic characteristics including physical properties and thickness of each stratum and location of ground water where occurring;
   2. (B) Chemical analyses identifying those strata that may contain acid- or toxic-forming, or alkalinity-producing materials and to determine their content, except that the Department may find that the analysis for alkalinity-producing material is unnecessary; and
   3. (C) Chemical analysis of the coal seam for acid- or toxic-forming materials, including the total sulfur and pyritic sulfur, except that the Department may find that the analysis of pyritic sulfur content is unnecessary.

3. (3) For lands within the permit and adjacent areas where the strata above the coal seam to be mined will not be removed, samples shall be collected and analyzed from test borings or drill cores to provide the following data:

   1. (A) Logs of drill holes showing the lithologic characteristics, including physical properties and thickness of each stratum that may be impacted, and location of ground water where occurring;
   2. (B) Chemical analyses for acid- or toxic-forming or alkalinity-producing materials and their content in the strata immediately above and below the coal seam to be mined;
   3. (C) Chemical analyses of the coal seam for acid- or toxic-forming materials, including the total sulfur and pyritic sulfur, except that the Department may find that the analysis of pyrite sulfur content is unnecessary; and
   4. (D) For standard room-and-pillar mining operations, the thickness and engineering properties of clays or soft rock such as clay shale, if any, in the stratum immediately above and below each coal seam to be mined.