Okla. Admin. Code § 40:50-1-3
Standards and specifications
Effective Jun 25, 202643 Ok Reg, Number 19<i><sup>1</sup>See first Editor's Note at beginning of this Chapter and Editor's Notice at 21 Ok Reg 3123.</i>; <i><sup>2</sup>See second Editor's Note at beginning of this Chapter for additional information about these two emergency actions.</i>; Added at 21 Ok Reg 2657, eff 7-11-04 <sup>1</sup>; Added at 22 Ok Reg 221, eff 10-27-04 (emergency); Added at 22 Ok Reg 1714, eff 6-25-05; Amended at 24 Ok Reg 287, eff 11-1-06 (emergency)<sup>2</sup>; Amended at 24 Ok Reg 2683, eff 6-4-07 (emergency)<sup>2</sup>; Amended at 25 Ok Reg 1527, eff 6-12-08; Amended at 27 Ok Reg 2667, eff 8-26-10; Amended at 32 Ok Reg 15369, eff 9-11-15; Amended at 33 Ok Reg 1190, eff 9-11-16; Amended at 35 Ok Reg 791, eff 9-14-18; Amended at 37 Ok Reg 1001, eff 9-11-20; Amended at 39 Ok Reg 812, eff 9-11-22; Amended at 40 Ok Reg 235, eff 11-1-22 (emergency); Amended at 40 Ok Reg 841, eff 8-11-23; Amended at 43 Ok Reg, Number 19, effective 6-25-26Board of Tests for Alcohol and Drug Influence
- (a) The provisions in this subsection only apply to the use of a device pursuant to an Installation Authority.
(b) The device shall:
- (1) Permit a free restart of the motor vehicle within two (2) minutes after the engine has shut off without requiring a further breath alcohol test.
- (2) Have a data storage system of sufficient capacity to facilitate the recording and maintaining of all daily driving activities and pictures for the period of time elapsed from one maintenance and calibration to the next. All daily driving activity records in this data storage system shall be maintained by the manufacturer or the licensed service center and shall be available to the Installation Authority, Monitor and/or the Board upon request.
- (3) Display tamper seals and a warning label that states: "Any person attempting to physically disable, disconnect or wire around this device or who intentionally fails to return the device upon request by the owner may be guilty of a misdemeanor under Oklahoma law (47 O.S. §11-902a)." If the device consists of separate pieces (e.g. a handset and separate base unit) a separate warning label shall be placed on each piece.
(4) Incorporate a camera on all BOT IDAP participant installations that is not located in the handset and meets the following requirements:
- (A) Each camera shall be mounted to the vehicle so that it does not obstruct the driver's view and provides a clear unobstructed view of the driver.
- (B) Has a sufficiently wide angle that it will be possible to determine whether the individual blowing into the device is seated in the driver's seat.
- (C) The technician shall take a reference image of the participant in the driver's seat during the installation appointment.
- (D) The camera shall operate in all lighting conditions and take an image of the driver with sufficient clarity and resolution to allow driver identification.
(E) The camera shall capture an image on each of the following events:
- (i) An attempted or successful breath alcohol test.
- (ii) Each time the vehicle is started.
- (iii) A circumvention.
- (iv) A retest violation.
- (c) The startup set point value for the device shall be an alcohol concentration of 0.025 g/210L.
- (d) The positive result value for the device shall be an alcohol concentration of 0.025g/210L.
(e) A retest feature is required while a vehicle's engine is in operation.
- (1) The first retest shall be required at a randomly variable interval ranging from five (5) to fifteen (15) minutes after passing the startup test and starting the vehicle's engine. Subsequent retests shall be required at a randomly variable interval ranging from fifteen (15) to forty-five (45) minutes from the previously requested test for the duration of the travel.
- (2) The device shall allow five (5) minutes for the retest to be completed.
- (3) The retest set point value shall be an alcohol concentration of 0.025 g/210L.
(4) An audible and/or visual indicator shall come on to alert the driver that a retest is in progress. Once a retest is in progress, failure to deliver a negative result within the time frame allowed shall:
- (A) Activate an audible and/or visual indicator inside the passenger compartment of the vehicle, until the engine is shutdown.
- (B) Record a retest violation in the data storage system, and
- (C) Disable the free restart.
- (f) A device may offer an “Extended Idle” feature after Board approval. An “Extended Idle” event may occur if:
- (1) The driver activates the event through the device’s handset or secure mobile application provided by the manufacturer; or
- (2) The device automatically activates the event, so long as no movement is being detected; and
- (3) The event is not activated when a retest request is in progress; and
- (4) The event automatically disables after one (1) hour has lapsed, or upon detection of vehicle movement, or by the driver disabling the event through the device’s handset or secure mobile application provided by the manufacturer; and
- (5) Upon disabling the event, the device immediately requests a retest and resumes normal retest requirements.; and
- (6) If the vehicle is turned off during the event, the free restart feature shall not be active and no retest will be requested.; and
- (7) The device records the events associated with the functionality in the data storage system.
- (g) The device shall have an approved anti circumvention feature(s) activated at all times.
(h) The device shall require a confirmatory test in response to a circumvention.
- (1) The device shall allow two (2) minutes for the confirmatory test to be completed.
- (2) The confirmatory test set point value shall be an alcohol concentration of 0.025 g/210L.
(3) An audible and/or visual indicator shall come on to alert the driver that a confirmatory test is in progress. Once a confirmatory test is in progress, failure to deliver a negative result within the time frame allowed shall:
- (A) Activate an audible and/or visual indicator inside the passenger compartment of the vehicle, until the engine is shutdown.
- (B) Record a circumvention violation in the data storage system, and
- (C) Disable the free restart.
- (4) Once the confirmatory test is passed, the device shall enter the normal retest sequence as provided by these rules.
- (i) The device shall have a breath sample collection volume limit at or above 1.2 Liters unless an alternative configuration has been approved by the Board.
- (j) In addition to the standards and specifications listed herein, the Board or its designee may impose additional requirements, as needed, depending upon design and functional changes in device technology and to ensure that the device functions properly and reliably.
<i><sup>1</sup>See first Editor's Note at beginning of this Chapter and Editor's Notice at 21 Ok Reg 3123.</i>
<i><sup>2</sup>See second Editor's Note at beginning of this Chapter for additional information about these two emergency actions.</i>
Added at 21 Ok Reg 2657, eff 7-11-04 <sup>1</sup>
Added at 22 Ok Reg 221, eff 10-27-04 (emergency)
Added at 22 Ok Reg 1714, eff 6-25-05
Amended at 24 Ok Reg 287, eff 11-1-06 (emergency)<sup>2</sup>
Amended at 24 Ok Reg 2683, eff 6-4-07 (emergency)<sup>2</sup>
Amended at 25 Ok Reg 1527, eff 6-12-08
Amended at 27 Ok Reg 2667, eff 8-26-10
Amended at 32 Ok Reg 15369, eff 9-11-15
Amended at 33 Ok Reg 1190, eff 9-11-16
Amended at 35 Ok Reg 791, eff 9-14-18
Amended at 37 Ok Reg 1001, eff 9-11-20
Amended at 39 Ok Reg 812, eff 9-11-22
Amended at 40 Ok Reg 235, eff 11-1-22 (emergency)
Amended at 40 Ok Reg 841, eff 8-11-23
Amended at 43 Ok Reg, Number 19, effective 6-25-26