(A)

1. (1) Before beginning the construction, erection, or manufacture of any building to which section 3781.06 of the Revised Code applies, including all industrialized units, the owner of that building, in addition to any other submission required by law, shall submit plans or drawings, specifications, and data prepared for the construction, erection, equipment, alteration, or addition that indicate the portions that have been approved pursuant to section 3781.12 of the Revised Code and for which no further approval is required, to the municipal, township, or county building department having jurisdiction unless one of the following applies:

   1. (a) If no municipal, township, or county building department certified for nonresidential buildings pursuant to division (E) of section 3781.10 of the Revised Code has jurisdiction, the owner shall make the submissions described in division (A)(1) of this section to the superintendent of industrial compliance.
   2. (b) If no certified municipal, township, or county building department certified for residential buildings pursuant to division (E) of section 3781.10 of the Revised Code has jurisdiction, the owner is not required to make the submissions described in division (A)(1) of this section.

2. (2)

   1. (a) The seal of an architect registered under Chapter 4703. of the Revised Code or an engineer registered under Chapter 4733. of the Revised Code is required for any plans, drawings, specifications, or data submitted for approval, unless the plans, drawings, specifications, or data are permitted to be prepared by persons other than registered architects pursuant to division (C) or (D) of section 4703.18 of the Revised Code, or by persons other than registered engineers pursuant to division (C) or (D) of section 4733.18 of the Revised Code.
   2. (b) No seal is required for any plans, drawings, specifications, or data submitted for approval for any residential buildings, as defined in section 3781.06 of the Revised Code, or erected as industrialized one-, two-, or three-family units or structures within the meaning of "industrialized unit" as defined in section 3781.06 of the Revised Code.
   3. (c) No seal is required for approval of the installation of replacement equipment or systems that are similar in type or capacity to the equipment or systems being replaced. No seal is required for approval for any new construction, improvement, alteration, repair, painting, decorating, or other modification of any buildings or structures subject to sections 3781.06 to 3781.18 and 3791.04 of the Revised Code if the proposed work does not involve technical design analysis, as defined by rule adopted by the board of building standards.