N.Y. Comp. Codes R. & Regs. tit. 6, § 380-3.2 – Permit applications.

(a) An application for a permit must satisfy the general requirements for complete applications contained in Part 621 of this Title.
(b) An application for a permit must satisfy the requirements of Part 617 of this Title, which include the submission of a properly completed environmental assessment form.
(c) A complete application for a permit must:
1. (1) contain information which thoroughly describes any proposed radioactive materials disposal, release, or site maintenance procedures in sufficient detail to:
  1. (i) demonstrate that the proposed action will comply with this Part;
  2. (ii) provide adequate justification for the proposed action; and
  3. (iii) enable the department to assess the nature and extent of any potential environmental impact.
2. (2) Include the following:
  1. (i) procedures to ensure compliance with the requirements of this Part; and
  2. (ii) any supplemental information which the department notifies the applicant is necessary to review the application.
(d) In addition to the information required by subdivision (c) of this section, a complete application for a permit authorizing the emission of radioactive materials to the air, discharge of radioactive material to ground or surface water, or incineration of radioactive material, must also include the following:
1. (1) an identification of each emission or discharge point and the effluent flow rate through each;
2. (2) an identification of all radionuclides to be emitted or discharged, and an estimate of the total activity and average concentration of each radionuclide in the effluent through each emission or discharge point in one year;
3. (3) a description of the effluent treatment, if any, that will be used to minimize the radionuclides in the effluent, how such systems will be maintained, and how wastes produced during treatment will be disposed of; and
4. (4) if effluent treatment will be used, an estimate of the total annual activity and average annual concentration of each radionuclide in the effluent both before and after treatment.
(e) In addition to the information required by subdivision (c) of this section, a complete application for a permit authorizing the use of radioactive materials in the environment must also include the following:
1. (1) a list of all radionuclides to be used;
2. (2) the total activity of each radionuclide;
3. (3) a description of the method of use or application; and
4. (4) the objective of the use to be performed, and the location of use.