B. Additional monitoring requirements for Class I non-hazardous waste injection wells.

1. (1) The discharger shall provide analysis of the injected fluids at least quarterly or, if necessary, more frequently to yield data representative of their characteristics.
2. (2) Continuous monitoring devices shall be used to provide a record of injection pressure, flow rate, flow volume, and pressure on the annulus between the tubing and the long string of casing.
3. (3) The discharger shall provide wells within the area of review as required by the discharge permit to be used by the discharger to monitor pressure in, and possible fluid movement into, ground water having 10,000 mg/l or less TDS except for such ground waters designated pursuant to Section 20.6.2.5103 NMAC. This Section does not require monitoring wells for Class I non-hazardous waste injection wells unless monitoring wells are necessary due to possible flow paths within the area of review.

C. Additional monitoring requirements for Class III wells.

1. (1) The discharger shall provide an analysis or description, whichever the secretary requires, of the injected fluids at least quarterly or, if necessary, more frequently to yield representative data.

2. (2) The discharger shall perform:

   1. (a) appropriate monitoring of injected and produced fluid volumes by whichever of the following methods the secretary requires:

      1. (i) recording injection pressure and either flow rate or volume every two weeks; or
      2. (ii) metering and daily recording of fluid volumes;

   2. (b) monitoring every two weeks, or more frequently as the secretary determines, of the monitor wells, required in Subsection C of Section 20.6.2.5205 NMAC for:

      1. (i) water chemistry parameters used to detect any migration from the injection zone;
      2. (ii) fluid levels adjacent to the injection zone; and
   3. (c) other necessary monitoring as the secretary for good cause may require to detect movement of fluids from the injection zone into ground water having 10,000 mg/l or less TDS except for fluid movement approved pursuant to Section 20.6.2.5103 NMAC.

3. (3) With the approval of the secretary, all Class III wells may be monitored on a well field basis by manifold monitoring rather than on an individual well basis. Manifold monitoring to determine the quality, pressure, and flow rate of the injected fluid may be approved in cases of facilities consisting of more than one Class III well, operating with a common manifold, provided that the discharger demonstrates that manifold monitoring is comparable to individual well monitoring.

   [9-20-82, 12-1-95; 20.6.2.5207 NMAC - Rn, 20 NMAC 6.2.V.5207, 1-15-01; A, 12-1-01]