1. (a) The design plans and construction specifications required pursuant to Env-Or 606.15(b) shall include the following, as applicable:

   1. (1) A description of the purpose and function of the remedial measures;

   2. (2) A list of applicable design criteria including, but not limited to:

      1. a. Site limitations;
      2. b. Physical properties of the soil and aquifer;
      3. c. Space restrictions;
      4. d. Subsurface obstacles, barriers, or both;
      5. e. Noise restrictions;
      6. f. Air and water discharge permit requirements;
      7. g. Remedial treatment system flow rates;
      8. h. Remedial treatment system efficiency; and
      9. i. Erosion and sediment control measures, and stormwater management practices for construction and post-construction site management, as applicable;
   3. (3) Remedial performance standards;
   4. (4) Characteristics, quantities, and locations of environmental media and contaminants to be treated or removed;
   5. (5) Expected waste products that will be generated and their means of disposal;
   6. (6) Pilot test results used in the preparation of the design; and
   7. (7) Manufacturer’s data describing the equipment in the design.
2. (b) Construction plans and specifications required pursuant to Env-Or 606.15(b) shall provide sufficient detail for construction of the remedial system or source removal project.
3. (c) The design plans and construction specifications prepared pursuant to this section shall be dated, signed, and sealed by the engineer of record.

Source. (See Revision Note at chapter heading for Env-Or 600) #8812, eff 2-1-07; ss by #10831, eff 6-1-15; ss by #14419, eff 11-4-25, EXPIRES: 11-4-35