1. (a) To prevent the release of fibers until properly packaged in accordance with Env-A 1803.05, the homeowner shall:

   1. (1) Adequately wet all ACM with amended water before removal; and
   2. (2) Maintain the ACM wet during and after removal.
2. (b) The homeowner shall carefully lower, not drop, throw, or slide, all ACM to the ground or floor.

3. (c) The homeowner shall remove non-load supporting structural members not previously stripped of ACM as follows:

   1. (1) Intact or in large sections whenever possible; and
   2. (2) By carefully lowering, not dropping, throwing, or sliding, those structural members to the floor.

4. (d) The homeowner shall remove ACM that is not associated with structural members as follows:

   1. (1) In small sections; and
   2. (2) By not allowing the ACM to accumulate on the floor.
5. (e) Following removal, the homeowner shall perform cleanup procedures using repeated HEPA vacuuming and wet cleaning techniques until no visible residue is observed in the work area.

Source. (See Revision Note #1, Revision Note #2, and Revision Note #3 at chapter heading for Env-A 1800) #14104, eff 11-1-24, EXPIRES: 11-1-34