- (a) In addition to other requirements set by rule, statute, or other law, each registered service technician shall complete and submit “Placed in Service/Inspection Report Form TAXI 08-2007 (REV. 07/14)” to the department.
(b) A registered service technician shall furnish the following on “Placed in Service/Inspection Report Form TAXI 08-2007 (REV. 07/14)”:
- (1) Name of business;
- (2) Full address, including city, state, and zip code;
(3) The following information about each taxi meter:
- a. Whether installed;
- b. Whether certified and the stamp number;
- c. Whether tested and calibrated for device license;
- d. Whether rejected;
- e. Whether repaired;
- f. Equipment number;
- g. Vehicle identification number;
- h. Registered plate number;
- i. Tire size;
- j. Make of meter;
- k. Serial number of meter;
- l. Model number of meter;
- m. Drop money;
- n. Plus money;
- o. Odometer reading-ending;
- p. Odometer reading-beginning;
- q. Total miles; and
- r. Total money value;
(4) The following information about each test data:
- a. Type of test;
- b. Actual discharge rate;
- c. Totalizer reading start; and
- d. Totalizer reading finish;
(5) The following information about each prover data:
- a. Prover temperature;
- b. Prover reading;
- c. Correction for expansion/contraction of prover;
- d. Volume correction for prover reading; and
- e. Prover reading corrected to 60 degrees Fahrenheit;
(6) The following information about each meter data:
- a. Gross meter reading; and
- b. Net meter reading;
(7) If an uncompensated run or systems that give both gross and net readings, the following:
- a. Average meter temperature;
- b. Volume correction for meter reading; and
- c. Meter reading corrected to 60 degrees Fahrenheit;
- (8) Net delivery error; and
- (9) Correct gross delivery error.
Source. (See Revision Notes #1 and #2 at chapter heading for Agr 1400) #12424, eff 12-1-17