1. (a) In addition to other requirements set by rule, statute, or other law, each registered service technician shall complete and submit “Inspection Report Form for Precision Scales (Category G) 03-17” to the division.

2. (b) A registered service technician shall furnish the following on form “Scale Inspection Report Form for Precision Scales (Category G) 03-17”:

   1. (1) Name of business;
   2. (2) Full address, including city, state, and zip code; and

   3. (3) The following information about each scale at the business:

      1. a. Device information including:

         1. 1. Certificate of conformance number;
         2. 2. Make, model, and serial number;
         3. 3. Capacity;
         4. 4. Division size;
         5. 5. Security seal number;
         6. 6. Indicator number; and
         7. 7. Whether it replaces a prior device, and, if so, the device’s serial number (SN#); and

      2. b. Inspection and testing information “as found” and “as left”, including:

         1. 1. Whether the device passes or fails;
         2. 2. Certification stamp number;
         3. 3. Scale at zero;
         4. 4. Level condition;
         5. 5. Display and weighing platter visible to the customer;
         6. 6. Scale protected from environmental factors;
         7. 7. Sufficient scale support;
         8. 8. Digital indications working properly;
         9. 9. Buttons and computations working properly;
         10. 10. Tested at location of scale use;
         11. 11. Shift test results; and
         12. 12. Load test results.

Source. (See Revision Notes #1 and #2 at chapter heading for Agr 1400) #12424, eff 12-1-17