Authority: IC 22-13-2-2; IC 22-13-2-13; IC 22-13-4-2

Affected: IC 22-12; IC 22-13; IC 22-15

Sec. 16. (a) The manufacturer's data plate shall be affixed on each completed industrialized building system or mobile structure in a permanent manner.

(b) The data plate shall be at least four (4) inches by six (6) inches and contain contrasting lettering.

(c) The data plate shall include the following:

1. (1) The manufacturer's name and complete address and the complete address of the manufacturing point of origin, if different.
2. (2) The serial number and model number.
3. (3) The date of manufacture.

4. (4) Electrical system, as follows:

   1. (A) Size of main service panel.
   2. (B) Phase.
   3. (C) Voltage.
   4. (D) Number of circuits.

5. (5) Capacities and fuel used, if applicable, for the following:

   1. (A) The water heater.
   2. (B) The furnace.
   3. (C) The air conditioner.

6. (6) Testing pressure for the following:

   1. (A) Potable water.
   2. (B) Drainage, waste, and vent (DWV).

7. (7) Design load requirement in pound per square foot (lbs./sq. ft.) as applicable for the following:

   1. (A) The roof.
   2. (B) The floor.
   3. (C) Wind.
   4. (D) Seismic.
8. (8) Titles of building codes used for design and construction.
9. (9) Page number or other identification where the installation instructions reference the connection of two (2) or more units.
10. (10) Energy conservation and accessibility, if applicable.
11. (11) Inspection authority identified.

(d) No additional information shall be on the data plate. If additional information is needed, it may be provided on a separate attachment.

(Fire Prevention and Building Safety Commission; 675 IAC 15-1.2-16; filed Aug 18, 2005, 4:30 p.m.: 29 IR 20; readopted filed Aug 4, 2011, 8:35 a.m.: 20110831-IR-675110254RFA; readopted filed Mar 10, 2017, 9:37 a.m.: 20170405-IR-675170005RFA; readopted filed May 11, 2023, 2:22 p.m.: 20230607-IR-675230104RFA)