5 C.F.R. § 330.213 – Selection from an RPL.

(a) Methods. An agency must adopt one of the selection methods in paragraphs (b), (c), or (d) of this section for a single RPL. The agency may adopt the same method for each RPL it establishes or may vary the method by location, but it must adopt a written policy for each RPL it establishes and maintains. While an agency may not vary the method used for an individual vacancy, it may at any time change the selection method for all positions covered by a single RPL.
(b) Retention standing order. For each vacancy to be filled, the agency places qualified RPL placement priority candidates in tenure group and subgroup order in accordance with part 351 of this chapter. In making a selection, an agency may not pass over a candidate in tenure group I to select from tenure group II and, within a tenure group, may not pass over a candidate in a higher subgroup to select from a lower subgroup. Within a subgroup, an agency may select any candidate without regard to order of retention standing.
(c) Numerical scoring.
1. (1) For each vacancy to be filled, the agency rates RPL placement priority candidates according to their job experience and education. The agency must use job-related evaluation criteria for the position to be filled that can distinguish differences in qualifications measured and must apply the criteria in a fair and consistent manner. The agency assigns the candidates a numerical score of at least 70 on a scale of 100, based on the evaluation criteria developed under this paragraph. The agency must grant 5 additional points to veterans' preference eligibles under 5 U.S.C. 2108(3)(A) and (B), and 10 additional points to veterans' preference eligibles under 5 U.S.C. 2108(3) (C) through (G).
2. (2) RPL placement priority candidates with an eligible numerical score are ranked in the following order:
  1. (i) Veterans' preference eligibles having a compensable service-connected disability of 10 percent or more in the order of their augmented ratings, unless the position to be filled is a professional or scientific position at or above the GS-9 level, or equivalent; and
  2. (ii) All other candidates in the order of their augmented ratings. At each score, candidates entitled to 10-point veterans' preference will be entered ahead of all other candidates, and those entitled to 5-point veterans' preference will be entered ahead of those candidates not entitled to veterans' preference.
3. (3) The agency must make its selection from among the highest three candidates available and may not pass over a veterans' preference eligible to select a nonpreference eligible.
(d) Alternative rating and selection.
1. (1) For each vacancy to be filled, the agency may use alternative rating and selection procedures (also called category rating) as described in 5 U.S.C. 3319 and part 337 of this chapter. The agency assesses RPL placement priority candidates against job-related evaluation criteria and then places them into two or more pre-defined quality categories.
2. (2) To use this method, the agency must:
  1. (i) Establish a system for evaluating RPL placement priority candidates that provides for two or more quality categories;
  2. (ii) Define each quality category through job analysis conducted in accordance with the “Uniform Guidelines on Employee Selection Procedures” at 29 CFR part 1607 and part 300 of this chapter. Each quality category must have a clear definition that distinguishes it from other quality categories; and
  3. (iii) Place candidates into the appropriate quality categories based upon their job-related competencies, knowledge, skills, and abilities.
3. (3) Veterans' preference must be applied as prescribed in 5 U.S.C. 3319(b) and (c)(2). Veterans' preference points as prescribed in paragraph (c)(1) of this section are not applied under this method.
4. (4) The agency must make its selection from the highest quality category in accordance with its category rating policy established under part 337 of this chapter.
(e) Application-based procedure.
1. (1) An agency may adopt an application-based procedure which allows RPL registrants to apply directly for RPL placement priority under an advertised vacancy announcement. Before using this procedure, the agency must establish policies and procedures for:
  1. (i) Informing RPL registrants of available vacancies;
  2. (ii) Informing RPL registrants of acceptable application formats, including how to permanently change initial registration information and how to apply changes only to the specific vacancy announcement for which the application is made;
  3. (iii) Determining the method under which the RPL registrant will be rated and ranked (paragraph (b), (c), or (d) of this section); and
  4. (iv) Informing each RPL registrant who applies under this method whether he or she was determined to be an RPL placement priority candidate and the outcome of the selection process, if the candidate was referred for selection.
2. (2) RPL registrants may not be removed from the RPL for failure to apply for a vacancy under this paragraph. Registration continues until it expires or the registrant is removed from the RPL under § 330.209.