A. After consulting with the director of the department of public safety, the assistant director for the motor vehicle division of the department of transportation shall:

1. 1. Certify ignition interlock devices.
2. 2. Publish a list of certified ignition interlock devices that includes information about the manufacturers of the devices and where the devices may be ordered.
3. 3. Make the list available to the courts and probation departments without charge.
4. 4. Establish standards and qualifications for technicians.

B. The assistant director shall adopt rules prescribing the requirements for certification and decertification of an ignition interlock device. These rules shall include:

1. 1. The procedure for certification of ignition interlock devices.
2. 2. Provisions to ensure the reliability of the ignition interlock device over the range of motor vehicle environments.
3. 3. Provisions to ensure that the ignition interlock device works accurately in an unsupervised environment.
4. 4. The procedure for decertification of an ignition interlock device for cause.

C. The assistant director shall not certify an ignition interlock device unless all of the following are satisfied:

1. 1. The device requires a deep-lung breath sample or another accurate measure of the concentration by weight of alcohol in the breath.
2. 2. The device is made by a manufacturer that is covered by product liability insurance in the amount of one million dollars per event and three million dollars in the aggregate.
3. 3. The manufacturer of the device indemnifies this state against any liability that may result from the use of the device.
4. 4. The device meets or exceeds the 2013 national highway traffic safety administration standards, including the ability to wirelessly transmit and receive information, take a digital image and include the global positioning system location of the device at the time of a requested test.
5. 5. The device is repaired or modified only by the manufacturer of the device.
6. 6. All of the device reporting that is required by sections 28-1461 and 28-1468 originates from the device manufacturer.

E. Each ignition interlock service provider who installs a certified ignition interlock device shall submit to the department a bond in a form to be approved by the assistant director and in an amount of at least two hundred thousand dollars. The bond inures to the benefit of any person who is ordered or required to equip a motor vehicle with an ignition interlock device pursuant to article 3 of this chapter or section 28-3319 and who suffers a loss because of either of the following:

1. 1. Insolvency or discontinuance of business of the ignition interlock service provider who installed the device.
2. 2. Failure of the ignition interlock service provider or agent or subcontractor of the ignition interlock service provider to comply with any provision of a contract that is required pursuant to section 28-1468 or any rule adopted pursuant to this section.