(a) The rear bumper shall be:

1. (1) Of pressed steel channel or equivalent material, at least three-sixteenths inch (3/16”) thick;
2. (2) A minimum of nine and one-half inches (9.5”) wide (high); and
3. (3) Of sufficient strength to permit being pushed by another vehicle without permanent distortion.

(b)

1. (1) Rear bumper shall be wrapped around back corners of bus.
2. (2) It shall extend forward at least twelve inches (12”) measured from rear-most point of body at floor line.

(c)

1. (1) Rear bumper shall be attached to chassis frame in such a manner that it may be easily removed.
2. (2) It shall be so braced as to withstand impact from a rear or side impact.
3. (3) It shall be so attached as to discourage hitching of rides.

(e)

1. (1) Tow eyes or hooks shall be furnished on the rear and attached so they do not project beyond the rear bumper.
2. (2) Tow eyes or hooks attached to the chassis frame shall be furnished by either the chassis or body manufacturer.
3. (3) The installation shall be in accordance with the chassis manufacturer's specifications.