delivered the opinion of the court:
Third-party plaintiff, Comet Industries, Inc., appeals from an order granting the dismissal of its third-party complaint, brought against Leslie-Locke Building Products Company, Inc., seeking indemnification. The facts are as follows.
Salvatore Vassolo (hereinafter referred to as “decedent”), an employee of Leslie-Locke Building Products Company, Inc., sustained injuries resulting in his death while operating a Saturn, three-stage, thermo forming machine. Plaintiff, the administratrix of the estate, sued Comet Industries, Inc., the manufacturer and seller of the machine, alleging that certain defects existed which made the machine unreasonably dangerous and proximately caused the death of the decedent.
Plaintiff alleged that the decedent was using the machine in the manner in which it was intended to be used and that the machine was defective and unreasonably dangerous at the time it left the possession of Comet Industries, Inc. The complaint listed five specific defects:
(1) the absence of enclosures around the machine which would impede entry into the immediate area of the machine during its operation;
(2) the absence of electrical shut-off devices on the aforementioned enclosures necessary to achieve a stop in the automatic operation of the machine should a person enter the enclosed area;
(3) the absence of photo electric circuitry surrounding the machine which would cause its automatic operation to cease should a person enter the enclosed area;
(4) the absence of additional “panic” buttons or switches in the immediate area of the machine by which all power to it could be cut off; and
(5) the capability of the machine to operate on its automatic cycle during the set-up periods in which it is being prepared to do a specific molding job.
Comet Industries (hereinafter third-party plaintiff) filed a third-party complaint against Leslie-Locke, third-party defendant, seeking indemnification for any and all judgments entered against it as a result of the original action. The third-party complaint alleged that the machine was in a safe condition when it left Comet’s premises and that it only became unsafe after it came into the control of third-party defendant. Any liability to the plaintiff was said to be purely passive and technical. The following wrongful acts on the part of third-party defendant were alleged to have caused the machine to become defective and unreasonably dangerous.
(.1) its selection of the area for installation of the machine in. its plant;
(2) its supervision and total control over the set up and instaUation of the machine and its design or failure to design, and instaH enclosures necessary for safe operation;
(3) its failure to equip such enclosures with any electrical shutoff devices and electrical circuitry so as to stop the automatic operation of the machine when a person entered the enclosed area;
(4) its faüure to design, plan and instaH panic buttons or switches; and
(5) its faüure to properly train, supervise and control the opera-, tion of the machine and to properly instruct its employees in the correct operation of the machine and to promulgate safety rules.
The third-party complaint also aHeged that the decedent had been permitted to operate the machine for a different purpose and in a different manner than that intended.
Third-party defendant moved to dismiss the third-party complaint for failure to state a cause of action. The motion was predicated on the decision in Burke v. Sky Climber, Inc. (1974),
The trial judge granted third-party defendant’s motion to dismiss. Third-party plaintiff then moved to file an amended complaint to state a cause of action under Rios v. Niagara Machine & Tool Works (1973),
In its amended third-party complaint, Comet aHeged, in relevant part, that if the machine was unreasonably dangerous at the time of the accident, it was only dangerous when used to perform some of its many functions without a suitable type of safety device. A duty was said to rest upon third-party defendant to supply protective measures and devices, and to provide proper training, supervision and control of its operators. Third-party defendant’s conduct in performing or failing to perform was alleged to be active misconduct, whfie that of third-party plaintiff was mere passive or technical negligence.
The amended third-party complaint was also dismissed and third-party plaintiff has appealed to this court. The sole issue presented for review is whether a manufacturer of machinery may maintain a third-party action against the purchaser when an employee of the purchaser is injured as a consequence of the safety devices (or lack of them) installed by the purchaser.
The Civil Practice Act permits third-party actions to be brought by a defendant against a person, not a party to the action, who is or may be liable to him for all or part of the plaintiffs claim against him. (Ill. Rev. Stat. 1971, ch. 110, § 25.) The third-party plaintiff must allege facts and not mere conclusions for the existence of the duty to indemnify, (Gillette v. Todd (1969),
This right to obtain indemnity does not exist where both parties are joint tortfeasors for the obvious reason that Illinois does not permit contribution among joint tortfeasors. Nonetheless, an exception to the no contribution rule appears in indemnity actions where the party who may be compelled to pay damages is only technically or constructively at fault. In such a case, the tortfeasor whose negligence is merely “passive” may be permitted to obtain indemnification from an actively negligent tortfeasor. Gillette v. Todd (1969),
Third-party plaintiff claims that the instant case falls within this exception. It is alleged that the machine as manufactured was not defective but only became defective when third-party defendant improperly integrated it into the larger working mechanism and outfitted it with safety devices chosen to be appropriate to its overall plan. Third-party plaintiff contends that these acts amounted to active misconduct, while its own acts could only be considered as passively culpable at most — its “culpability” being limited to the manufacture of a nondefective product which was sold- to third-party defendant who was to engineer a finished installation.
We believe that third-party plaintiffs attempt to come within the purview of the active-passive negligence exception is both artificial and irrelevant to a proper disposition of the case. The original complaint is not based on a negligence theory; that is, it is not alleged that an act of negligence on the part of the defendant (third-party plaintiff) caused the injury. Instead, plaintiff has founded her cause of action on a strict liability theory, alleging that the machine was in a defective and unreasonably dangerous condition when it left third-party plaintiffs possession.
A manufacturer who sells a product in a defective condition unreasonably dangerous to the user is subject to liability for physical harm thereby caused, notwithstanding the fact that he has exercised all possible care. (Restatement (Second) of Torts § 402A (1965); Suvada v. White Motor Co. (1965),
In Burke v. Sky Climber, Inc. (1974),
Third-party plaintiff attempts to distinguish Burke on the ground that the third-party complaint there alleged only that the third-party defendant was negligent in failing to maintain the product and discover defects. It is alleged here that third-party defendant had a duty to properly attach the requisite safety features to a nondefective machine. Rios v. Niagara Machine & Tool Works (1973),
The courts in Kossifos v. Louden Machinery Co. (1974),
«# t> # [T]he exception applies only where the two tortfeasors are tortfeasors owing to their respective negligences, because the theory essentially involves a comparing of negligences to determine the more causative fault of the same type. Here, however * * * potential liability is not based on negligence, and the theory is therefore inapplicable.”
The plaintiff in Stanfield was seriously injured while operating for the first time a machine purchased by her employer from the defendant-manufacturer. An indemnity action was brought against the employer on the active-passive exception, aUeging that adequate instructions or supervision had not been given to the employee who, being inexperi- • encéd, had not used it properly. In reviewing the denial of the third-party defendánt’s motion to dismiss, the court stated at pages 999-1000:
“* * * [T]hat the basis of liability is the putting into the stream of commerce of a defective and dangerous product and that the liabffity proceeding therefrom is not based on ordinary negligence but is based on the consideration of protecting the public from such products. In such cases there is no active-passive negligence relationship between the parties upon which the doctrine of indemnity can operate.”
Under Suvada v. White Motor Co. (1965),
We also point out that the mere fact that third-party defendant would be liable to plaintiff if plaintiff had sued it alone or jointly with the original defendant is not a sufficient basis for indemnity. A defendant is permitted to implead only a person who is or may be liable to him for plaintiff’s claim; he cannot tender a new defendant to the plaintiff. Muhlbauer v. Kruzel (1968),
For the foregoing reasons, the order dismissing the third-party complaint is affirmed.
Affirmed.
BURMAN and ADESKO, JJ., concur.
Notes
We note that the Supreme Court decision in Rios v. Niagara Machine & Tool Works (1974),
