The United States Court of Appeals for the Sixth Circuit has certified the following question to this court for our determination:
“May the risk-benefit test of the Ohio Products Liability Act be used in attempting to prove a design defect in a properly functioning disposable cigarette lighter?”
For the reasons that follow, we answer the certified question in the affirmative.
In cases arising prior to the enactment of the Ohio Products Liability Act, we established that there are “two alternatives available to determine whether a product design is in a defective condition * * *[:] the consumer-expectation standard [and] a second, alternative, risk-benefit standard.” State Farm Fire & Cas. Co. v. Chrysler Corp. (1988),
We made clear that these standards are not mutually exclusive, but instead constitute “a single, two-pronged test” for determining whether a product is defectively designed. Cremeans v. Internatl. Harvester Co. (1983),
In enacting the Ohio Products Liability Act, the General Assembly codified this analytic approach at former R.C. 2307.75,
*509 “(A) Subject to divisions (D), (E), and (F) of this section, a product is defective in design or formulation if either of the following applies:
“(1) When it left the control of its manufacturer, the foreseeable risks associated with its design or formulation as determined pursuant to division (B) of this section exceeded the benefits associated with that design or formulation as determined pursuant to division (C) of this section;
“(2) It is more dangerous than an ordinary consumer would expect when used in an intended or reasonably foreseeable manner.” (Emphasis added.) Am.Sub. H.B. No. 1,142 Ohio Laws, Part 1,1661.
Thus, “Section 2307.75 allows the trial court to apply one or another, or both, of two distinct ‘design defect’ standards. The plaintiff can choose to proceed under one or both tests.” (Footnote omitted.) O’Reilly & Cody, Ohio Products Liability Manual (1992) 70-71, Section 6.08. Indeed, “[t]he very existence of a risk/benefit analysis in the Ohio cause of action for design defect helps those plaintiffs who would otherwise lose in a consumer expectation case.” (Footnotes omitted.) Id. at 80, Section 7.05.
The Act does not contain any exception for properly functioning products, and does not limit the applicability of the risk-benefit test to products which malfunction. Instead, the Act collects all product liability claims into a standard set of theories of recovery, one of which is that the product in question was defective in design or formulation as described in former R.C. 2307.75. See former R.C. 2307.7KM) and 2307.73(A). 142 Ohio Laws, Part 1,1675-1676,1677-1678. There is absolutely no basis under the common or statutory law of Ohio for creating a dichotomy between properly and improperly functioning products when applying the risk-benefit test.
Nevertheless, the district court relied heavily on Caveny v. Raven Arms Co. (S.D.Ohio 1987),
In Caveny, plaintiffs sought to recover from the manufacturer of a .25 caliber handgun, a so-called Saturday Night Special, which was used to murder plaintiffs’ decedent. Plaintiffs alleged that this handgun had no legitimate purpose and, therefore, its risks far exceeded its benefits. The court, finding the risk-benefit standard inappropriate in this case, reasoned as follows:
“This standard is only applicable in situations in which a product has functioned improperly, not when products have functioned as intended. For instance, in Cremeans * * * a tractor that slipped off a trailer and overturned did not have roll-over protection. Similarly, in Knitz * * * a punch press lacked safety*510 guards. In both of these cases, the products operated improperly due to design inadequacies. Here, by contrast, the handgun operated as intended; when fired a bullet struck an individual in its path. In other words, the risk/utility test is only proper when the product could be made safer through an alternative design and not when the product is by its nature dangerous.” Id.,665 F.Supp. at 532-533 .
In Koepke, the court relied on Caveny to find that “[i]n the absence of any allegation by appellants that the BB gun functioned improperly, we conclude that the risk-benefit test does not apply in this case * * Id.,
According to respondents, “[t]he risk-utility test may only be applied when something goes wrong with the product,” i.e., when the product “malfunctioned.” (Emphasis sic.) By way of illustration, respondents explain that the products in Knitz and Cremeans “operated improperly, and not as intended, due to design inadequacies. Here, by contrast, the disposable lighter operated properly and as intended; when the lighter was activated, it produced a flame. Had the lighter exploded when activated due to a design inadequacy, however, then, and only then, would the risk-utility test be applicable.” (Emphasis sic.)
In attempting to limit Ohio’s risk-benefit test to those situations in which a product malfunctions, the district court, respondents, and the courts in Caveny and Koepke proceed from the premise that the products in Knitz and Cremeans failed to operate properly and as intended. However, the limitation cannot stand because the premise is faulty; no malfunction occurred in either the punch press in Knitz or the tractor in Cremeans.
In Knitz,
Similarly, in Cremeans,
Thus, Knitz and Cremeans provide no support for the proposition that Ohio’s risk-benefit test is applicable only in those situations where a product has functioned improperly. To the contrary, these cases stand for the proposition that a product may be found defective in design under the risk-benefit test where the manufacturer fails to incorporate feasible safety features to prevent harm caused by foreseeable human error.
Moreover, even if we followed Caveny, we would still find the risk-benefit test to be appropriate in the present case. According to Caveny, a product functions improperly, and thus the risk-benefit test applies, “when the product could be made safer through an alternative design.” Under this reasoning, the risk-benefit test would apply when a lighter (the product) could be made safer through the inclusion of child-resistant features (an alternative design).
In fact, this is precisely the analysis that the court later employed in Aikman v. BIC Corp. (Nov. 13, 1991), S.D.Ohio No. C-3-89-272, unreported. On facts virtually identical to those in the case sub judice, the court in Aikman held summary judgment to be inappropriate on plaintiffs claim that “the lighter was defective, under a risk-benefit analysis, because it did not include child resistant features.” Id. at 12-13. In reaching its holding, the court distinguished its prior decision in Caveny as follows:
“In Caveny, the plaintiff alleged that the product by its very nature was unsafe, not that it could be made safer. It was on that basis that Judge Spiegel concluded that the gun was not defective under a risk-benefit analysis. Unlike the plaintiff in Caveny, the Plaintiff herein argues that Defendant could have made the lighter safer, by adopting an alternative design which would make the lighter childproof; therefore, Caveny does not provide the basis for sustaining this branch of Defendant’s motion for summary judgment.” Id. at 12.
Respondents argue, however, that “Aikman was in error when it repudiated the analogy to a hand gun made positive in Caveny. As the United States Court of Appeals for the Sixth Circuit recognized in Byler v. Scripto-Tokai Corp.,
Unlike Kentucky, Ohio does not require the plaintiff in a design defect case to prove that a product is “unreasonably dangerous.” In Knitz, supra,
Unlike Kentucky law, R.C. 2307.75(D) limits the application of the “unavoidably unsafe” defense to design defect claims involving “[a]n ethical drug or ethical medical device,” thus precluding its application in claims involving disposable lighters. See, also, Knitz, supra,
Also, unlike Kentucky, Ohio does not recognize the “obvious danger” defense in a design-defect claim. While provision is made in R.C. 2307.76(B) for an “open and obvious risk” defense in failure-to-warn claims, no such provision is contained in R.C. 2307.75 with respect to design-defect claims. Instead, R.C. 2307.75(B)(2) lists “the likely awareness of product users * * * of those risks of harm” as one factor to be considered in determining the foreseeable risks associated with a product’s design. However, this factor may be outweighed by the other statutory risk-benefit factors set forth in R.C. 2307.75(B) and (C).
Lighters are commonly used and kept around the home, and it is reasonably foreseeable that children would have access to them and attempt to use them. “It has been estimated, for example, that 5,800 residential structural fires, 170 deaths, and 1,190 injuries occur each year because of children under 5 playing with lighters. The annual cost of children playing with lighters has been estimated at $300 million to $375 million.” Annotation, Products Liability: Lighters and Lighter Fluid (1993),
In Queen City Terminals v. Gen. Am. Transp. Corp. (1995),
*513 “The first and foremost objective of strict liability is to promote product safety. The doctrine of strict products liability provides manufacturers a strong incentive to design, manufacture, and distribute safe products. Prosser & Keeton [Law of Torts (5 Ed.1984) ], Section 4 at 25-26. ‘The basis for the rule is the ancient one
Based on all of the foregoing, we hold that the risk-benefit test of the Ohio Products Liability Act may be used in attempting to prove a design defect in a properly functioning disposable cigarette lighter. We answer the certified question in the affirmative.
Judgment accordingly.
Notes
. An amendment after this case arose eliminated the consumer-expectation test, leaving this section of the statute otherwise substantively the same. Am.Sub.S.B. No. 350, 146 Ohio Laws, Part II, 3867, 3950.
. Respondents also cite several decisions from other jurisdictions in which courts have denied recovery on claims involving disposable lighters without child-resistant features. Respondents then argue that these cases represent “[t]he vast weight of precedent,” and that Aikman “has not been followed in any other reported decision.” The truth is that courts are split over this issue, both among and within various jurisdictions. See Annotation, Products Liability: Lighters and Lighter Fluid (1993),
. In finding that the dangers of disposable butane lighters are both obvious and unavoidable, the court in Byler reasoned that the production and maintenance of a flame are inherent aspects of a lighter-, and that “[a]ny disposable butane lighter of any design necessarily must possess these characteristics.” Id. at 3^1. Under R.C. 2307.75(E), recovery is barred where “the harm for which the claimant seeks to recover compensatory damages was caused by an inherent characteristic of the product which is a generic aspect of the product that cannot be eliminated without substantially compromising the product’s usefulness or desirability and which is recognized by the ordinary person with the ordinary knowledge common to the community.”
However, R.C. 2307.75(E) does not apply automatically to bar- claims involving the propriety of incorporating safety features into the product. Fundamentally, such claims admit that one or more
Stated differently, such a claim brings into focus an aspect or characteristic of the product which would not be apparent in the absence of such an allegation. The obvious inherent characteristics of a lighter are the production and maintenance of a flame. These characteristics cannot be eliminated by any design. However, this fact alone would not preclude recovery any more than would the fact that the punch press in Knitz must necessarily create a pinch point, or that the lawnmower in Eldridge must necessarily' have rotating blades. These are not the characteristics which are alleged to have caused the harm. Instead, in each case another aspect or characteristic of the product which could have been eliminated comes into focus by virtue of the proposed safety feature. In Knitz, the press allowed the ram to descend while the operator’s hand was within the point of operation. In Eldridge, the lawnmower allowed the operator’s foot to slide into the point of operation. In the present case, the lighter was susceptible to activation by children. It is these latter aspects or characteristics of the product that become the focal point of an R.C. 2307.75(E) analysis; and the question whether these characteristics could have been eliminated depends on the propriety of the proposed alternative design inclusive of a safety feature. Any other application of R.C. 2307.75(E) would generally eliminate the failure-to-guard case, a result clearly not envisioned under R.C. 2307.75. Thus, R.C. 2307.75(E) does not apply to preclude recovery in this case simply because the production and maintenance of a flame are inherent characteristics of a lighter.
