1. Master andservant: failure to guard machinery: negligence. Defendant is proprietor of a box factory in Clinton, and on June 29, 1906, plaintiff was operating a circular cross-cut saw therein, cutting rubbish for wood, when the tooth of the saw caught a block, hurling it into his eye, destroying the sight. . . , ühe saw extended through a groove in the . table three or four inches above. Pieces of board were placed and held with the right hand on a carriage which was pressed toward the saw with the body and left hand. The parts not used were thrown in the woodpile, and those of value put aside on the table for use. The small blocks or pieces were cleaned away in the evening. There was no shield or guard on the saw. By chapter 149, Acts 29th General Assembly (see section 4999a, Code Supp. 1907), it is provided that “in all manufacturing or other establishments where machinery is used ... all saws . . . shall be properly guarded.” The evidence tended to show that a saw could? be effectually guarded by hanging a board large enough to obstruct any pieces the teeth might catch and throw over between it and the operator, or by covering with a hood or box so placed that the material to be sawed could pass underneath, and that such appliances were proper to guard against injury.to the operator. This evidence was practically undisputed; the defendant proceeding on the theory *3that, unless saws were customarily guarded in similar factories, it could not be charged with negligence. There might be something in this position but for the enactment of the statute referred to. The Legislature evidently concluded that the necessity of a guard ought not to depend on the custom of particular factories, but on that of those using similar saws for like purposes, and, as many establishments thoughtful for the ‘safety of their employees had found it practical to guard different instruments including saws, all establishments where machinery is used should properly guard them. The duty to guard saws, at least when practicable, is fixed by law. The only inquiry left open is whether the guard is proper. That other factories may have ignored this law furnishes no excuse to any one for not complying with ° its terms. The evidence left little or no doubt but that to guard this and other saws in defendant’s factory was practical, that either of the appliances mentioned would have furnished adequate protection without interfering with the operation of the saws, and therefore might have been found to have been proper. It follows that in entirely omitting to provide any guard for the protection of the operator the defendant was negligent.
2. same- assumpcoñtributÓSrv: negligence. II. Did plaintiff assume the risk? He had been employed as a roustabout at this factory for the five years previous to the accident, and prior to that during vacations ^rom attending school. When those regularly operating machines were away, he often ^ pkceSj and in tMg way ke had handled temporarily the planer, the matcher, the printer, the nailer, and for a day or a half day at a time the crosscut saw on four or five different occasions, and during the week before the accident. He had noticed the saw carry two or three little blocks over to the other side of it, but testified that he had never seen it throw any over with any degree of force, and that he was not aware of any danger to be apprehended therefrom. Another witness who had *4operated the saw several years testified that it would catch a block so as to hurl it with force only occasionally — about once a week. To do this, of course, the saw teeth must catch into the block somewhat firmly, and this would not be likely to occur frequently, so that plaintiff, though in the factory a long time, might not have appreciated the danger from this source. If he did not appreciate the danger, and the jury might so have found, then he did not assume the risk. See Harney v. Chicago, etc., Railway Co., 139 Iowa, 359. Enough has been said to indicate that whether plaintiff ivas guilty of contributory negligence was for the jury. Several other errors are assigned and regarded as untenable, but, not being argued or noticed in the statement of propositions or points, are not reviewed.— Affirmed.
AI-generated responses must be verified and are not legal advice.