253 F. 191 | N.D.N.Y. | 1918
“The ornamental design for a candle as shown and described.”
The specification contains the following description:
“The design, as illustrated in the drawing, is a pillar or column, substantially square in cross-section, mounted upon a substantially cylindrical • longitudinally fluted pedestal, and surmounted by a bell-shaped cap, with its base lines set back from, the square edges of the pillar top.”
We have then the following elements in combination, which make up the patented design or ornamental candle, and each element must be deemed material, viz.: (1) The pillar or column, square in cross-section; (2) the substantially cylindrical longitudinally fluted pedestal; and (3) the bell-shaped cap, with its base lines set back from the square edges of the pillar top. The whole candle is made integral. In this art a bell-shaped cap surmountihg the pillar or column of the candle was old. The cylindrical longitudinally fluted pedestal was also old. A cylindrical pillar or column was also old, as were pillars or columns of various and many other shapes. It is claimed by complaint that the square column was not old. The evidence shows heyond question that the so-called Cleopatra candle was old. The pillar- of this candle is square, but not of the same diameter from top to bottom. It slopes and narrows the column gradually and uniformly from base to top. It was not made in the United States, so far as appears, but was imported, and sold and used here long prior to the granting of the patent in suit.-
The claim for this patent, as first presented, read: “The ornamental design for a candle as shown ” The words “and described” were added by amendment after rejection by the examiner. The present specification, as above quoted, was put in by amendment in place of the following :
*193 “Of which the following is a specification, reference being had to the accompanying drawing, forming a part thereof; The figure is a perspective view of the candle, showing my new design.”
On appeal, after rejection the applicant said:
“It is submitted that the design, consisting of the square column resting upon a cylindrical pedestal and mounted by a bell-shaped cap, whose base lines are set back from the square edges of the column, thus having an offset between the flat sides of the pillar and its cylindrical pedestal, and an offset at the top between the square edges of the‘column and base line of the cap, is not shown in any of the references cited.”
On appeal the examiners in chief said:
“There appears to be a certain unity in design between a rectangular form of the candle and that of the tip, which possesses some degree of novelty and invention.”
On this the reversal seems to have been based, and it follows, I think, that the novelty found in this combination consisted, not in the square form of the candle, but in the peculiar and, as found, novel combination of the bell-shaped tip with the square column; that is, the setting back of the base of the bell-shaped cap from the square edges of the square column having flat sides. While, in view of the prior art, it may be doubted whether there is patentable invention in this combination containing this feature, I am inclined to hold the patent valid, as the presumption is in its favor. This candle is certainly attractive and ornamental, and the combination is new. Complainant’s candle is not designed for use as a light giver, a burner, but as an ornament. As compared with the round candle, the square candle as a burner, or for lighting purposes, would be and is inferior. The square candle would not show utility or improvement. It would bum down faster at the sides than at the corners, and cause waste and an inferior light.
There is no prior art showing the combination of the patent, but each and every element, standing alone, is substantially old. The coach candle, Defendant’s Exhibit T T, shows a bell-shaped cap set back from the rounded top edge of the column, which is cylindrical; but the shoulder is not sqtiare, but rounded and curved, forming a sort of trough between the rounded edge of the cylindrical column and the base of the bell-shaped top. Therefore the bell-shaped cap does not have its base lines “set back from the sqtiare edges of the pillar top.” The pillar top, or top of the pillar of this “coach candle,” Exhibit T T, does not have square edges or a square shoulder, as does the complainant’s candles, but still the edge of the bell-shaped top is set back from1 the edge of the column. As to patentability I may cite Bush & Lane Piano Co. v. Becker Bros., 222 Fed. 902, 138 C. C. A. 382 (2d Circuit), where the court said:
“Tlie drawing of the design siiows an upright piano case in the conventional form. The casual observer, unless his attention were particularly directed to the new features, would hardly be able to distinguish the patented design from many of the designs found in the prior art. However, we agree with Judge Hazel in the statement that: ‘On comparison with the prior art, because of the configuration of the colums, the paneling, and the substantiality thereof, it is easily distinguishable from other upright pianos.’*194 There are some characteristic features of the design in controversy which distinguish it from those of the prior art, although 'the general contour of the case is alike in all, and several of the cases of the prior art show designs which, to the ordinary .purchaser, whose attention is not called to details, would.seem to embody the principal features of the design of the patent. Nevertheless, having in mind the rule applicable to design patents, we cannot say that it is anticipated or void for lack of patentability.”
In Grelle v. City of Eugene, Or., 221 Fed. 68, 137 C. C. A. 18, the court held:
“That each separate element in a patented design was old does not negative invention, which may reside in the manner in which they are assembled.”
In Ashley v. Weeks-Numan Co., 220 Fed. 899, 136 C. C. A. 465, the same doctrine was expressly held:
“Tested by this rule, the defendant infringes. It is true that there are some differences between the design of the complainants and the design of the defendant. But the differences are differences of detail, and not of substance. The defendant has not made a Chinese copy of the complainants’ inkstand, and yet it imparts to the mind the same general appearance, which would deceive an ordinary observer into buying one inkstand believing it to be the other.”
In Strause Gas Iron Co. v. Wm. M. Crane Co., 235 Fed. 126, 131, 148 C. C. A. 620, 625, the court (C. C. A. 2d Circuit), said:
“Tbe test for Invention is to be considered the same for designs as for mechanical patents; i. e., was' the new combination within the range of the ordinary routine designer? We believe that any one starting to design sad-irons, with the art before him, and governed only by considerations of proportion and plan, would have had no difliculty in making the plaintiff’s iron.”
“To sustain a design patent, the design must involve something more than mere-mechanical skill; and whether the assembling of old design elements into one unitary design is patentable depends on whether, in the particular case, such assembling rises to the level of invention and tbe result possesses originality and beauty.”
There is this to be said: That in complainant’s candle, as in all candles, the column rests upon the pedestal and the tip upon the column. This is the order of assembly in all candles. Having selected a square form of column o £ equal diameter from base to top, with plain flat sides and without ornamentation of any kind, it was joined in the old way to the old and well-known pedestal before described. Then came the selection with, the aid of the prior art of a tip and also the adoption of a mode or form of combining it with the column. Here we find a departure from the prior art and a new combination in one harmonious, ornamental whole. We find some degree of originality and beauty. This involved more than mere selection and assemblage. All this was not mere mechanical act. A skilled mechanic or candle maker might have hit this combination, and he might not. In a somewhat crowded art, no one had.
Having arrived at the conclusion that the patent is valid, the question is presented; Does the defendant infringe? The defendant’s candle has the same cylindrical longitudinally fluted base or pedestal as does complainant’s candle. Its pillar or column is square in cross-section, except that a depressed panel is cut out. from the pedestal to the top of the column on each of the four otherwise flat sides. The sides of defendant’s candle are not flat, because of this depression. This depression occupies about two-thirds of the width of each side. ¿Still the general form of the column is square. Where the column joins the hell-shaped cap, which is substantially identical with complainant’s cap, there is no shoulder, except at each of the four corners of the column. There Is no setting back of the base lines of the bell-shaped cap from the square edges of the pillar top, except at and adjoining the four corners. There we find this setting hack. Place the two candles side by side, or at a short distance from each other, and we perceive this difference in the structural appearance of the two candles; hut place them at a considerable distance from each other In the same room, and from the observer, and the general appearance and effect is the same. We would not, under such circumstances, note the difference in appearance or form of the candle, unless examining for a difference. It would make a difference whether the room were brilliantly or dimly lighted in noting this difference. It should also be noted that defendant has cut off the corners of its bell-shaped top, or tip, giving it eight sides (not all of the same width, however), instead of four sides; but this does not change the general appearance.
On the market the horizontally fluted cylindrical pedestal is attractive in the combination. When the candle is in its stick or socket, this is to an extent immaterial, as the pedestal is mostly hidden from
“Candles are molded in a great variety of stapes; tlie most common sliape being that of a plain cylinder of varying diameter and length. A great variety of ornamental forms for religious and decorative purposes are molded in numerous prismatic cross-sections, ’as square, triangular, octagonal, etc. They may also be molded, longitudinally or spirally fluted. The latter form was originally turned in a lathe, but is now made in molds, and in ejecting the candles from such molds tfie candles are. made to .rotate. Decorated candles are of every color, shape, and design. Eed, green, pink, white, and yellow are the most popular colors. The decorations are made of wax, and put upon the candles by hand. The wax is colored, so as to give the decorator’s artistic taste the widest possible range.”
The combination of these elements, substantially as shown, except the setting back mentioned, and the plain, square column of equal diameter from its base to its top, was old (see the Cleopatra candle), and defendant had1 the right to use that combination; but the peculiar formation of the top end, where the bell-shaped tip joins the 'column in combination with a square column of uniform diameter from base to top, was new. This the defendant, in view of the patent, had no right to appropriate and use. Defendant did appropriate this set-back formation, so far as the four corners of the candle are concerned,' but not in its entirety, for it cut away a portion of each of the flat sides of the column, making the depression mentioned, and1 cut bade up to the very base of the bell-shaped cap. Hence, except at the comers, as stated, there is found in defendant’s candle no setting back of the base lines of the cap from the square edges of the pillar top. Defendant also appropriated in his combination the square form of equal diameter from base to top of the column, cutting a depressed panel therein on each side.
It is not the case of “a Chinese copy,” but still complainant had a new and a novel design, pleasing to the eye, and defendant has copied it, with the changes mentioned, leaving the same general impression on the beholder who sees the two. The resemblance is such as to deceive the ordinary observer and purchaser. It has not used the Cleopatra candle column. The evidence conclusively shows that for a long time defendant purchased these ornamental candles from the complainant, or rather from a company 'making ornamental candles in accordance with the design of this patent and sold them in its business. The candles so purchased had been marked “Patented” by complainant; but this, after a time, was omitted in the candles furnished defendant for its trade at its request. The defendant finally concluded' to make and sell a candle of its own malee, which it did, and thereafter made and sold the candle alleged to be an infringement of complainant’s patent and candle. Defendant used' cartons and labels similar to complainant’s; but this not material, as unfair competition is not involved in this case. The defendant created the differences between the two candles intentionally. Can we say it
In this case the difference between the actual design of 'the pedestal and column of the Cleopatra candle and the pedestal and column of the complainant’s candle are not very great, and still are quite marked. This is true of the general appearance of the two. The
“The acts of Congress which authorize the grant of a patent for designs contemplate not so much utility as appearance; and the thing invented or produced, for which a patent is given, is that which gives a peculiar.or distinctive appearance to the manufacture or article to which it is applied. It is the appearance to the eye that constitutes mainly, if not entirely, the contribution to the public which the law deems worthy of recompense, and identity of appearance, or sameness of effect upon the eye, is Ore main test of substantial identity of design. It is not essential to identity of design that the appearance should be the game to the eye of an expert. If, in the eye of an ordinary observer, giving such attention as a purchaser usually gives, two designs are substantially the same — if the resemblance is such as to deceive such an observer, and sufficient to induce him to purchase one, supposing it to be the other — the one first patented is infringed by the other. * * * We hold, therefore, that if, in the eye of an ordinary observer, giving such attention as a purchaser usually gives, two designs are substantially the same, if the resemblance is such as to deceive such an observer, inducing him to purchase one, supposing it to be the other, me first one patented is infringed by the other.”
Subsequent cases are to the same effect. See quotation from Ashley v. Weeks-Numan Co., supra.
I have examined and compared quite a number of ornamental candles in evidence, some of which have ornamentation other than the general from and design of the candle itself. Exhibits O, P, a,nd R are candles the general form of which is nearly square in cross-section, but each has rounded comers a,nd a deep, angular groove in each of its otherwise flat sides. The pedestal in each is smooth, as is the tip, and this portion slopes with a slight curve gradually from the sides of the column to the wide. The tip of each may be said to be bell-shaped, but the structural formation, and general appearance are quite different from those of complainant’s candle. The design is markedly different. Exhibit G is twisted, and has a bell-shaped tip, which is set back from the .sides of the column; but it was never square in cross-section (although nearly so), as it has rounded corners, and the sides, otherwise flat, are depressed, made concave. It is of greater diameter at the base than at the top, and has no pedestal.
I atn constrained to the opinion that complainant’s patent is valid, and infringed by defendant, giving to his 'patent the limitations we should, in view of the prior ait.
There will be a decree accordingly.