185 Mo. 301 | Mo. | 1904
Plaintiff, in the service of the defendant, was assisting in placing in position an iron beam when the beam fell and struck him arid'inflicted injury; he sues for $25,000 damages, alleging that, the accident Occurred through defendant’s negligence.
It was an iron beam, called in the record an eye-beam or I-beam, about 18 feet long, weighing several hundred pounds. The object was to fasten it to girders in the roof, so as to have it in position to connect with machinery to be afterwards attached.
There were six or eight of those beams to be used and the task of placing them was assigned to the plaintiff and his fellow-servant Pagan. The mode of operation was to swing the beam up to the height desired, by
0
The petition charges that the defendant was negligent in three particulars: First, that it made the bolt out of inferior iron and allowed scrap steel to be' mixed with the scrap iron out of which it was made, in consequence of which the steel in the mixture became burnt and rotten, rendering the bolt weak in places; second, that the defendant did not properly examine and inspect the bolt; third, defendant caused the block and tackle to be taken away before the beam was fastened. The answer was a general denial and a plea of contributory negligence.
At the close of all the evidence the ease was given to the jury, who returned a verdict for the defendant. Final judgment followed, and the plaintiff appealed.
We will consider the evidence bearing on the three alleged acts of negligence in the inverse order in which they are pleaded.
3. The removal of the block and tackle.
The office of the block and tackle as shown by the evidence was to lift the beam up to the position in which it was to be fastened. As soon as it was lifted up the ends were placed in position and two bolts were inserted through each end. These bolts when first inserted are called in the evidence “temporary bolts,” which signifies that after being inserted they are to be adjusted by washers before being fastened permanently with the nuts, and in thus adjusting them they may be removed one at a time, leaving the other' in place to hold up the beam. When the washers are applied and the bolt is adjusted the nut is screwed tight and the bolt is then -permanent. When the temporary bolts are inserted they are. sufficient to hold the beam in place while the operators are making the adjustment. One bolt on each end is sufficient to hold the beam alone; the only reason two are placed in each end is that machinery is to be after-wards attached and then two are required. While the other beams, before this one, were being .placed in position the block and tackle were left at , each beam until the bolts were securely fastened and then they were moved on to swing the next beam into place'. But there was nothing, in the evidence to indicate that the block and tackle were kept there to hold or to help hold the beam from falling, but only that it was left there until it was needed elsewhere and because it would be needed for the next beam as soon as the one in hand-was finished. When the last beam was lifted up and the temporary
The plaintiff was not entitled to go to the jury on the question of the defendant’s negligence in removing the block and tackle.
2. The failure of the defendant to exánime, inspect and test the holt.
That is not (in itself and nothing more) an act of negligence for which the defendant would be liable in damages to the plaintiff. The gravamen of the plaintiff’s complaint is that the defendant negligently furnished him a defective bolt. If the bolt was not defective the defendant is not liable even if it did not inspect it; and the circumstances might be such that even if the bolt was defective; the defect co.uld not have been discovered by inspection, and in that event failure to inspect would not, per se) be actionable negligence. The fact that the defendant did make inspection and test, if such was the fact, might or might not, according to the other facts in the ease, be a defense which tiie defendant might or might not, as he was advised, set up against the plaintiff’s cause of action. In pleading non-inspection in his petition, the plaintiff has, gone out of his way to anticipate a possible defense.
The complaint is not merely that the defendant furnished a defective bolt, but that it did so negligently, which means that it did so without observing that degree of care that devolves on the master in such a case. In support of the allegation that the defendant acted negligently in the matter it was competent for the plaintiff to show, if he could by his evidence, that the defect was of such a character that it could have been discovered if the bolt had been inspected, and from that fact
The court refused to submit the • question to the jury to say whether or not there had been a proper inspection, and in so doing the court was right, if for no other reason, because the only evidence in the case on that point was that the defendant did cause reasonable inspection to be made.
Assuming that the defendant made the bolt whose • breaking caused the accident '(about which, however, there is a question) the evidence showed that it was engaged in the nut and bolt business on a tolerably large scale, making 60,000 or 70,000 bolts a day, that they are all inspected by the men who handle and examine them before they are sent to the threading department, and after that they are examined ag’ain It was shown that to test a bolt, it had to be broken and of course destroyed. The custom was to test a bolt occasionally by breaking-it and examining the fibre; that pro-' cess showed whether the iron they were using'was what it should be and whether a change in the material or process should be made. There was no evidence to the contrary.
Some of plaintiff’s witnesses testified that if, as was claimed by the plaintiff, steel scraps had been suffered to get into the mass of scrap iron of which the bolts were made, the defect which it would produce
1. We come to the last alleged act of negligence,. • which in the order pleáded is the first, that is,
That the defendant negligently furnished a defective bolt. '
In considering whether or not the plaintiff was entitled to go to the jury on this specification we must give him the benefit of every conclusion that could law•fully be drawn from his own evidence, aided, if it is aided, by the evidence of the defendant. Where the evidence of the defendant contradicts that of the plaintiff a question is presented for the jury, not for the court. Yet when the court is asked to authorize a jury to find a fact from the testimony so vague and uncertain that the inference to be drawn from it amounts to scarcely more than conjecture or the possibility that the fact might exist, then the court ought to look at the character of the evidence on the other side and if the case
The defendant was engaged in manufacturing bolts on a considerable scale, 60,000 or 70,000 in a day. It also frequently bought bolts from other manufacturers to fill orders and to keep bolts so purchased in stock. There is no positive evidence that the bolt in question was made by defendant, though there ivas evidence tending to show that it probably was. But assuming that it was made by the defendant, there was no evidence to show when it was made, the significance of which was to show that it was made.during the period indicated in the evidence of some of the plaintiff’s witnesses when in consequence of a strike new men, ‘‘ green hands,” were'employed. The almost impossibility of identifying this bolt, as to who made it and when, will be at once appreciated when we think of the volume of the.defendant’s business in this line. Sixty or seventy thousand bolts in a day amount to 600,000 or 700,000 in ten days, and so on, soon amounting to millions. The plaintiff has done the best he could to trace the bolt to its origin and ascertain its date, but he is lost in the wilderness. His own inability to furnish .any positive proof on this point exemplifies the impossibility of the task he would impose on the defendant of ascertaining that this bolt out of the millions it made and handled was without flaw.
The scientific fact on which the plaintiff relies is that scrap steel mixed with scrap iron does not make good material out of which to make a bolt, because in the melting of the mass the steel melts quicker than the< iron and by the time the iron is melted the steel is so burned that its tensile strength is destroyed and the bolt is weakened. This fact is shown also in the evidence for the defendant, except that in defendant’s evidence a distinction is drawn between hard steel and what was called railroad carbon steel between- which
The evidence for the plaintiff tended to show that for a period of two or three months before this accident new men, or ‘‘green hands” as they were called, were employed to gather up scrap iron for the furnaces, and some of these men testified that they gathered scrap steel as well as scrap iron in the mass, but none of those men knew or pretended to say that scrap steel was melted with the scrap iron out of which the-bolts' were made; 'when they, as common laborers, were done with gathering up and delivering the piles of scrap, their connection with the work was ended. The evidence for defendant shows that in the collection of scrap iron for this business pieces of scrap steel were liable to get into piles; it also shows that it was to the interest of the defendant to keep it out, and it shows the method of defendant used to separate the steel from the iron, and no other practical method is suggested in the plaintiff’s evidence.
Plaintiff in his brief refers to the testimony of Mr. High, a witness for defendant and superintendent of defendant’s works, as showing that scrap steel was used with scrap iron in making bolts; we do not so understand that witness. This is what he said on cross-examination by plaintiff’s attorney:
Q. Do you handle any kind of steel out there? A. Yes, we handle steel, yes; we buy that in billets»
Q. In billets? A. Very low carbon.
Q. Do you put steel scrap with the wrought iron scrap, when'you. make these bolts? A. N.o, not unless it is some of our steel, railroad carbon steel, which is about equal to iron.
Q. I mean, do you put scrap iron that has steel in it, have it piled up there on piles? A. Oh, yes, yes, sir.
Q. Some iron and some steel mixed? A. Yes,
Q. It does come with the iron? A. Yes, sir.
Q. Now, i-f steel, a certain quality of steel, is mixed ' with this scrap- iron, why, it will melt before the scrap iron,-won’t it? A. Yes, but we don’t do that; we never do that.
Q. Yon have experienced men in your hobo gang that separates this scrap iron from scrap steel? A. Well-, yes, most of them have been there long enough to know the difference between iron and steel.
Q. That is the reason they are called “hoboes” because they are inexperienced? A. No, that is a name they have given the laborers; I don’t know why they call them hoboes.
Q. Well, do you call those fellows that you had there in the scrap pile that.we have had on the witness stand experienced iron men, Mr. High? A. Well, no, I would not call them experienced iron men, certainly not.
Q. Did you ever tell them not to put in scrap steel with scrap iron? A. I caution them every day.
Q. You did caution them? A. I always do.
Q. Why did you do that, Mr. High? A. For the simple reason if they get a hard piece of steel in" the pile, it ruins the pile and we can’t do anything with it; say, for instance, we make a hundred pound pile, and they put in ten pounds of hard steel, it will just ruin a hundred pounds of iron; we can’t- use it; we can’t roll it.
Q. You employ there most any man that comes along to pick up iron, don’t you, in that hobo gang? A. Oh, yes, will do that most any time.
Q. And yet it was necessary for those men that you pick up off from the streets here to tell a certain quality of steel they should pick out and put in a certain other quality of steel? A. No, you are mistaken on that; you’re mistaken there.
If the witnesses upon whom the plaintiff relies to prove that scrap steel was gathered up with scrap iron are competent to know steel from iron, the men-whom Mr. High says he set to .separate the steel from the iron ought to be deemed compótent also.
Plaintiff introduced as expert witnesses blacksmiths who had long experience in working with iron, and who said that the best bolts were made of the best iron — Norway iron — and that scrap iron would not make the best bolts. But on further examination it appeared that they were talking about hand-made bolts for certain kinds of machinery. All the evidence on the subject was to the effect that machine-made bolts in all the large manufactories were made of, scrap iron, and such bolts were in common use for ordinary purposes. “There was no evidence'to the contrary. These expert witnesses handled this broken bolt in the presence of the jury, and pointed out what they said were indications of burnt steel in its composition. Expert witnesses on the other side' also handled it and showed it to the jury and said that it showed no such indications and gave no sign of a defect; they also said that bolts of that size without flaw were sometimes broken by a strong hand screwing a nut with a strong wrench.
Assuming that there' was substantial evidence- for the plaintiff tending to show that there was a defect in this bolt, there was not any substantial evidence to show that in the .ordinary course of its business and with the use of such care as was to be expected of a man of ordinary prudence and experience engaged in business of that kind the defendant knew or' could have known that this bolt was defective. Among the great number of bolts turned out by a concern like this it would be wonderful if occasionally a defective bolt was not found in
Appellant complains of the giving and refusing of some of the instructions, but it is immaterial what the instructions were, because there was no evidence on which the court could sustain a verdict for the plaintiff..
The judgment is affirmed.