173 Wis. 561 | Wis. | 1921
The respondent Cleveland was employed at a sand and gravel crane. A part of the machinery consisted óf a belt earner about 200 feet long which was constructed on an incline and was operated by a motor. The belt was driven by a pulley and as it moved upward carried sand in the sag of the belt. The belt was twenty inches wide and the pulley at the upper end was twenty-two inches wide and thirty-six inches in diameter. A platform was built near the pulley at the upper end of the belt, and it was at this pulley that the respondent Cleveland was injured. At the time of his injury he had gone to the platform with a stick of dressing for the purpose of applying it to' the pulley, the belt having stopped. In response to a signal the superintendent stopped the machinery and was then told by the respondent Cleveland to start it again. The respondent' Cleveland continued to apply the dressing to the pulley while the belt wás in motion, and in so doing the glove which
“All pulleys over eighteen inches in diameter which are exposed to contact must be guarded.”
Order No. 1 is in part as follows:
“All belts, ropes, or chain-driving machinery or shafting, and all secondary belts, ropes, or chains; in short, all belts, ropes, or chains exposed to contact, except belts which are so small or those which move so slowly that there is no possibility of danger, must be guarded. . . .
“Note (a) The term ‘belt’ or ‘secondary belts’ means belts which transmit power and do not apply to sanding or polishing belts, or belts used for abrasive purposes; such belts must be guarded where possible.”
The Industrial Commission found that the pulley at which the respondent Cleveland was injured came within the provisions of Order No. 2. This finding was confirmed by the' trial court. The trial court correctly held that the finding was supported by substantial^ credible evidence and could not be set aside for that reason. It is contended that the pulley in question is not covered by Order No. 2 because not exposed to contact within the meaning of that order. The circumstances of this case show that it was exposed to contact in the ordinary course of the company’s business. We do not think the phrase “exposed to contact” means to continuous or frequent contact, but to contact in the ordinary and usual course of the operation of the plant without regard to its frequency or infrequency. We shall not attempt to determine whether the belt in question transmits power within the meaning of Order No. 1. It is not necessary to a decision of this case.
By the Court, — Judgment affirmed.