Bridgewater v. State Through Dept. of Corr.Bridgewater v. State Through Dept. of Corr.
Henry BRIDGEWATER
v.
STATE of Louisiana Through the DEPARTMENT OF CORRECTIONS.
Supreme Court of Louisiana.
Gregory F. Gambel, Cummings & Gambel, New Orleans, for applicant.
William J. Guste, Jr., Atty. Gen., Houston T. Penn, J. Marvin Montgomery, Asst. Atty. Gen., for respondent.
CALOGERO, Justice.
Plaintiff, Henry Bridgewater, an inmate at the Louisiana State Penitentiary at Angola filed suit against the State of Louisiana through the Department of Corrections, seeking damages for injuries he sustained at the penitentiary. Following a trial before a commissioner of the Nineteenth Judicial District, the district court rendered judgment for the plaintiff in the sum of $5,000.00. Defendant appealed. The court *384 of appeal,
Plaintiff was a porter responsible for janitorial duties at the prison license plate manufacturing plant. On Sunday, February 18, 1973, plaintiff was ordered by a Department of Corrections employee, one T. Jones, to use the sheet metal shearing machine to cut cardboard backing for use in the shipment of finished license plates.[1] Plaintiff protested, contending that operating the shearer was not part of his job. He did nonetheless do as he was told. During the cutting process the cardboard became lodged in the machine. As plaintiff leaned over the shearer in order to unjam the cardboard with his left hand, he accidentally struck a metal bar, the machine's operating control, which was located near his feet at the front and beneath the machine a few inches off the ground. That triggered the switch and activated the machine. The blade dropped and amputated two fingers at the knuckle on plaintiff's hand.
It is well established that an employer has an obligation to provide his employees with a working place and conditions which are reasonably safe considering the nature of the work.
We agree with the lower courts in their finding the Department of Corrections negligent. As the court of appeal found, the shearer was designed to be operated with a finger guard which would have prevented the injury which plaintiff suffered. According to the deposition testimony of Mr. Bob Joyce, a field service representative of the machine's manufacturer from 1955 to 1967, the machine had had the finger guard attached to it originally. This was evident, he urged, from the fact that the machine had holes not in use, placed in the shearer upon its manufacture for the sole purpose of attaching the safety device. At the prison no one could remember the use of a finger guard on the machine. It had evidently been removed. The safety device had been removed and had never been replaced.[2] Also plaintiff's operation of the dangerous machine was not under the supervision of a prison official. If the guard had not been removed or had it been replaced, the accidental injury could not have occurred. The accident was reasonably foreseeable since inmates were using the machine, unusually dangerous because of the absence of the safety device. The risk involved was within the scope of the duty owed by the defendant to the inmates. There existed an ease of association between the risk presented by defendant's actions under the overall circumstances and plaintiff's resulting injuries. See Hill v. Lundin and Associates, Inc.,
We disagree, however, with the court of appeal's finding that plaintiff was contributorily negligent and that such contributory negligence was a proximate cause of his injuries. Contributory negligence is defined as plaintiff's conduct which falls below the standard of care to which he should perform for his own protection. The standard is determined by reasonableness of behavior under the circumstances. The party relying upon the contributory negligence defense has the burden of proving it. *385 Smolinski v. Taulli,
Louisiana courts have acknowledged that an employee is not entirely free to avoid known risks; he cannot simply decide not to do the work without perhaps subjecting himself to loss of his job. Chaney, supra. The standard for contributory negligence on the part of an employee was enunciated in Miller v. Employers Liability Insurance Company of Wisconsin,
Emerging as criteria for determining an employee's contributory negligence are: (1) relative knowledge of the danger by the supervising employee and the injured employee; (2) relative control over the employee's situation; (3) the degree to which the employee's conduct is voluntary on his part; (4) alternatives available to the employee; (5) obviousness of the danger; and (6) relative ability to eliminate the danger.
"(T)he standard of care imposed on the workman is less stringent than in ordinary cases where contributory negligence is at issue because the employee at times must involve himself in known hazardous endeavors in order to retain his employment." Martinez v. U.S. Fidelity and Guaranty,
An inmate, in particular, is not in a position to refuse to perform a job known to be dangerous. See Stilley v. State,
Unlike the plaintiff in Parker v. State,
We therefore find that plaintiff was not contributorily negligent. Accordingly, we reverse the judgment of the court of appeal and reinstate the district court judgment awarding plaintiff $5,000.00.
Decree
For the foregoing reasons, the ruling of the court of appeal is reversed and the district court judgment is reinstated.
COURT OF APPEAL JUDGMENT REVERSED; DISTRICT COURT JUDGMENT REINSTATED.
NOTES
Notes
[1] In his report Commissioner Bergeron described the operation of the machine as follows:
The shears are a large machine containing a stationary blade or cutting edge and a second moving blade which is activated by a large bar beneath the machine. Stepping on the bar causes the cutting blade to drop, cut whatever is beneath it and return to its position.
[2] In his deposition, Mr. Joyce, the manufacturer's representative, stated that finger guards for that type of machine were always readily available.
[3] Since this Court finds no contributory negligence, we pretermit discussion of the other arguments raised by plaintiff in brief.