Breach of Manufacturer’s Warranty — Strict Liability — Summary Judgment. Barnes was injured in an accident in August 1984, while driving his motorcycle. Barnes deposed that he had grown up riding motorcycles. Apparently he had owned and operated three of his own and had been using motorcycles for approximately 17-18 years. He had owned and operated a 1976 Harley-Davidson 1200 cc Super Glide model motorcycle for several years before the accident in August 1984. His father purchased the motorcycle for him in 1979. It was conceded that at the time of its purchase the motorcycle was in good operating condition and Barnes did not consider that the vehicle was without any equipment essential to its efficient operation. At the time of the acquisition, the motorcycle was not designed to have as standard equipment, and did not have, “crash bars” (to protect the motorcycle in the event of falling over during operation). Although Barnes had thought about installing crash bars as a safety feature, he had never done so. Also, the motorcycle was equipped with a standard motorcycle sealed beam unit (Par. 46 5 Í4 ”) with a maximum candlepower of 22,000 on high beam and 10,500 on low beam, designed pursuant to Federal Motor Vehicle Safety Standard 108. That headlamp had been standard equipment on Harley-Davidson motorcycles since 1976 and there had been no change in design throughout the period of installation and use. Barnes stated that he had come to the belief that *779 the candlepower was inadequate at higher speeds but although he had personally replaced the sealed beam unit several times he had never sought to increase the candlepower nor placed a second or auxiliary lamp on the motorcycle. Barnes also conceded that he had no complaints about the operation of the vehicle or equipment upon the motorcycle prior to the accident in August 1984.
On August 7,1984, one Bobby Howard was operating his automobile on Highway 78 just west of Lexington, Georgia. Howard experienced electrical failure in the ignition and his car stalled. Howard parked the stalled auto on the right shoulder of the road with the left front and back wheels just to the right of the white line constituting the edge of the westbound lane of the highway, thus just off the highway. After working unsuccessfully on the car for more than an hour to get it restarted, Howard and a friend apparently started to push the stalled vehicle toward Lexington. The friend apparently was pushing from the rear of the vehicle and Howard was pushing at the driver’s door and presumably guiding the vehicle in its forward progress. Howard and his friend heard a loud noise which Howard stated he thought to be a truck. The appellant Barnes was approaching the stalled auto on his motorcycle at about 50-55 mph. Howard stated he never saw the approaching motorcycle and Barnes stated he never saw the stalled car. Barnes struck the driver’s door of the stalled vehicle which was projecting several inches to a foot beyond the white line and thus slightly into the eastbound lane. Barnes’ motorcycle struck the edge of the auto door with the right lower part of the motorcycle, causing him to lose control and ultimately to cause injuries to his right leg resulting in the amputation of the leg at a point just below the knee.
As a result of this accident, Barnes filed a complaint against his own insurer (Leader) and Howard. Because Barnes had deliberately refused coverage on uninsured motorist and paid no premium therefor, his insurer (Leader) was granted summary judgment and removed from the litigation. Barnes then brought Harley-Davidson in as a party defendant as the manufacturer of the motorcycle, upon the basis of strict liability contending that Harley-Davidson misdesigned the particular model motorcycle by not providing crash bars as standard equipment and using an inadequate headlight, both defects together making the motorcycle, as designed, not reasonably suited for the use intended, i.e., a safe two-wheeled vehicle. He further argues that Harley-Davidson was negligent in not warning Barnes as a consumer of the inherent dangers involved in using a product with no crash bars and inadequate lighting, a fact which he contends Harley-Davidson clearly would have greater knowledge about than a consumer. After extensive discovery, Harley-Davidson moved for summary judgment contending there was no breach of any express or im *780 plied warranty and that Barnes had assumed any risk involved in the use of the motorcycle without crash bars or with what he considered inadequate lighting. The trial court granted the motion for summary judgment filed by Harley-Davidson and this grant forms the basis for the appeal by Barnes. Held:
Although Barnes enumerates 7 separate asserted errors, each is simply a different facet of the same argument. We are at once confronted with the obvious facts that Barnes was a very knowledgable and experienced operator of motorcycles. He had operated the motorcycle upon which the accident occurred for approximately 4-5 years. He had been taught rules of safe driving and was familiar with motorcycles generally, including the different equipment that was furnished as standard safety features and equipment on different models of motorcycles. He conceded that there was no apparent defect in the model 1200 cc Super Glide when it was purchased and that he had used it successfully throughout his ownership. He conceded further that the motorcycle was provided with all the equipment that it was designed to have. He knew the model he owned and was riding at the time of the accident did not come equipped with crash bars. Though he knew crash bars probably afforded greater safety for the rider, he never undertook to purchase or install crash bars on the motorcycle. Moreover, he acknowledged that the headlamp worked as designed; it came on when energized and went off when switched off. He agreed that the high beam afforded more forward light than did the low beam but did not know whether the lamp was on high or low beam at the time of the accident. Though Barnes deposed that he personally believed the lamp afforded too little light, especially in very dark areas when driving at high speeds, he had changed the seal beam on several occasions but had made no efforts to increase the intensity of the light by installation of a more powerful seal beam or to attach a second lamp. It was shown and not disputed that the headlamp installed by Harley-Davidson was in accordance with federal standards and that Harley-Davidson had used the same design and intensity light since 1976. In substance then the evidence showed that Barnes had no complaints concerning the operation of the motorcycle throughout his ownership and that if there were defects within his own contemplation, these defects were patent.
In relation to the asserted design defect of inadequate light, we are constrained to conclude that the evidence established the light met federal standards. Assuming that Barnes had concluded the light nevertheless was inadequate, it is also clear that such defect was at least as well known to him as to the manufacturer. The conclusion is inescapable that by his continuing use of the motorcycle even after his belief that the light was insufficient, Barnes assumed any risk attendant to continued operation. In an earlier “headlight” case, this
*781
court quoted with approval the following language: “If a manufacturer does everything necessary to make the machine function properly for the purpose for which it is designed, if the machine is without any latent defect, and if its functioning creates no danger or peril that is not known to the user, then the manufacturer has satisfied the law’s demands. We have not yet reached the state where a manufacturer is under the duty of making a machine accident proof or foolproof. . . . [H]e is under no duty to guard against injury from a patent peril or from a source manifestly dangerous. Nor is there a duty on the manufacturer or seller to warn of obvious common dangers connected with the use of a product.” (Citations and punctuation omitted.)
Poppell v. Waters,
As to the alleged failure by the manufacturer to install crash bars as standard equipment, we have previously considered such an allegation. In the case of
Hunt v. Harley-Davidson Motor Co.,
Likewise, we must reject Barnes’ argument that the motorcycle was designed with an inherent defect. As previously discussed, there is no independent responsibility upon a manufacturer of a motorcycle to furnish crash bars as standard equipment. The facts show that the motorcycle was functional and suitable for the purpose for which it was intended. The light was a standard light which apparently met federal standards. The facts thus establish that Harley-Davidson had done everything necessary to make the machine function for the purpose intended. Barnes made no showing in the record there were any latent defects. For all the record shows, the ordinary use of the machine created no danger or peril that was not known to Barnes. Under these circumstances, Harley-Davidson satisfied the demands of the law for product safety and suitability.
Coast Catamaran Corp. v. Mann,
Judgment affirmed.
